Skip to content
Loading map…

Studio Nails

2020 Sherwood Drive Sherwood Park AB T8A 3H9 · Personal Services

4 inspections

  1. Monitoring Inspection

    3 infractions

    • 13. Is single-use or uncleanable equipment being used as intended (Critical)?
      • Two used nail files were observed stored in staff station drawer. Informed operator to discard and ensure files are only used once.
    • 27. Is the facility maintained in a visibly clean state and are environmental surfaces cleaned and disinfected properly?
      • Nail stations were observed to have acrylic dust around the inside areas of the drawers. Informed operator to ensure all stations are properly cleaned.
    • 33. Are general nuisance conditions, other than those noted in other violations, being prevented at this personal services facility (Non-Critical)?
      • The Pre-empt RTU spray bottle used for environmental cleaning and disinfection was expired. Please ensure a valid a spray bottle is available onsite.
  2. Demand Inspection

    0 infractions

  3. Risk Management Inspection

    0 infractions

  4. Monitoring Inspection

    3 infractions

    • 14. Is single-use or uncleanable equipment being used as intended (Non-Critical)?
      • Used nail files, and Dremel bit sanding paper had not been discarded.Ensure that porous items that cannot be cleaned and disinfected are discarded after each use.
    • 17. Is reusable equipment cleaned properly (Critical)?
      • Some of the instruments being used were starting to develop rust, including and not limited to, the culticle nippers. Equipment should be inspected prior to disinfection, if equipment is not longer in good condition, it is to be replaced.
    • 20. Is reusable equipment disinfected properly?
      • 1. Disinfectant was not being changed daily, was not being tested with test strips, and testing was not being logged. If disinfectant is being used for multiple days, it must be tested daily and the daily tests must be logged. 2. Disinfection time is not being physically monitored. Ensure that manufacturer's instructions for disinfectant are being followed and that equipment is only soaked for 20 minutes and then immediately rinsed.