Aleppo Kebab
605 Church St N, Ajax ON L1T 0B8 · Food Safety Inspections
6 inspections
- Routine
4 infractions
- Minimum of 1 Certified Food Handler per hour of operation?
- * Fail to provide a minimum of 1 certified food handler per hour of operation
- Operator to ensure a minimum of 1 certified food handler is present during every hour of operation
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Manual dishwashing: Wash, rinse, sanitize technique
- * Fail to use proper wash/rinse/sanitize technique
- Chlorine sanitizer concentration must be at least 100 parts per million and not lower than 24°C for at least 45 seconds
- Operator to ensure the proper wash/rinse/sanitize dishwashing technique is applied
- Adequate protection against the entrance of insects, vermin, and rodents
- * Fail to ensure storage areas are clean and organized to facilitate monitoring of pest control
- * Fail to prevent the entrance of insect / rodent / pest
- Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
- Operator to ensure food premise shall be protected against the entry of pest
- Minimum of 1 Certified Food Handler per hour of operation?
- Routine
1 infraction
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
- Operator to ensure all food contact surfaces/equipment/utensils/multi-service articles are made of materials that can be readily cleaned and sanitized
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- Routine
3 infractions
- Food protected from potential contamination and/or adulteration
- * Fail to protect food from contamination and/or adulteration
- Operator to ensure all food is properly stored, displayed, transported and served to prevent contamination
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
- * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
- Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
- Food protected from potential contamination and/or adulteration
- Re-Inspection
0 infractions
- Routine
7 infractions
- Potentially hazardous food is held at 4°C (40°F) or lower
- * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
- Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
- Food is prepared in a safe manner
- * Fail to ensure food is prepared in a safe manner
- Operator to ensure potentially hazardous foods are prepared in a safe manner
- Washing hands thoroughly before and after handling food
- * Food handlers fail to wash hands as often as necessary to prevent the contamination of food or food areas
- Operator to wash hands before putting on disposable gloves
- Food protected from potential contamination and/or adulteration
- * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
- Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
- Manual dishwashing: Wash, rinse, sanitize technique
- * Fail to use proper wash/rinse/sanitize technique
- Operator to ensure the proper wash/rinse/sanitize dishwashing technique is applied
- Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
- * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
- Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
- Potentially hazardous food is held at 4°C (40°F) or lower
- Routine
1 infraction
- Food is prepared in a safe manner
- * Fail to ensure food is prepared in a safe manner
- Operator to ensure potentially hazardous foods are prepared in a safe manner
- Food is prepared in a safe manner