Skip to content
Loading map…

Chuck's Roadhouse Bar & Grill

14375 Simcoe St, Port Perry ON L9L 1G3 · Food Safety Inspections

8 inspections

  1. Routine

    4 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
    • Sanitary maintenance of and provision of required supplies in staff / public washroom facilities
      • * Fail to keep washroom in good repair, clean and sanitary condition
      • Operator to ensure the washroom facilities are maintained clean and in good repair
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
  2. Routine

    3 infractions

    • Food is prepared in a safe manner
      • * Fail to ensure food is prepared in a safe manner
      • Operator to ensure potentially hazardous foods are prepared in a safe manner
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Manual dishwashing: Wash, rinse, sanitize technique
      • * Fail to use proper wash/rinse/sanitize technique
      • Quaternary ammonium compound must be at least 200 parts per million and lower than 24°C or more for at least 45 seconds
      • Operator to ensure the proper wash/rinse/sanitize dishwashing technique is applied
  3. Routine

    1 infraction

    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
      • Operator to ensure food premise shall be protected against the entry of pest
      • Provide proof of contract with licensed pest control operator to control and remove insect/pest infestation
  4. Routine

    5 infractions

    • Food is prepared in a safe manner
      • * Fail to ensure food is prepared in a safe manner
      • Operator to ensure potentially hazardous foods are processed, prepared and manufactured at temperatures between 4°C (40°F) and 60°C (140°F) within 2 hours
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Iodine concentration must be at least 25 parts per million at 24°C or greater for at least 45 seconds
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
      • Provide proof of contract with licensed pest control operator to control and remove insect/pest infestation
    • Walls clean and in good repair
      • * Fail to ensure walls of food premise kept clean and in good repair
      • Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
  5. Re-Inspection

    0 infractions

  6. Routine

    8 infractions

    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
    • Minimum of 1 Certified Food Handler per hour of operation?
      • * Fail to provide a minimum of 1 certified food handler per hour of operation
      • Operator to ensure a minimum of 1 certified food handler is present during every hour of operation
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning hot holding unit immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 60° C or higher.
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to ensure the appropriate chemicals and/or temperatures are used for proper washing and sanitizing
    • Manual dishwashing: Wash, rinse, sanitize technique
      • * Fail to use proper wash/rinse/sanitize technique
      • Operator to ensure the proper wash/rinse/sanitize dishwashing technique is applied
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
    • Floors clean and in good repair
      • * Fail to ensure floor of dishwashing area kept clean and in good repair
      • Operator to ensure floors are kept clean and in good repair
  7. Re-Inspection

    0 infractions

  8. Routine

    6 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
    • Food is prepared in a safe manner
      • * Fail to ensure food is prepared in a safe manner
      • Observed potentially hazardous foods not being thawed in an appropriate and safe manner
    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to provide sufficient detergent, chemicals, or required water temperatures for washing and sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to ensure the appropriate chemicals and/or temperatures are used for proper washing and sanitizing
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure food contact surfaces are cleaned & sanitized after each use or as often as necessary
      • Operator to ensure all food contact surfaces are properly cleaned & sanitized