Skip to content
Loading map…

Copper Keg Pub & Kitchen

304 Taunton Rd E, Whitby ON L1R 0H4 · Food Safety Inspections

Inspection summary

Copper Keg Pub & Kitchen has been inspected 8 times by Durham Region Health Department since February 3, 2025. The most recent inspection, on June 29, 2026, recorded 4 infractions.

2 of 8 inspections on record found no infractions at all. In the past 12 months there were 5 inspections with 13 infractions recorded. The higher-risk findings here relate to: Protecting food from contamination, Handwashing and staff hygiene and Food temperature control.

The number of infractions per inspection has stayed roughly the same over time.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Protecting food from contaminationHigher risk

    This covers how food is stored, prepared and displayed: raw meat kept away from ready-to-eat food, food covered and stored off the floor, and nothing dripping or splashing into it. Cross-contamination from raw to cooked food is a direct route for salmonella and E. coli.

    Recorded 4 times across 4 separate inspections, most recently on June 29, 2026. For example: Food protected from potential contamination and/or adulteration

  • Handwashing and staff hygieneHigher risk

    Hands are the main way germs like norovirus move from people to food. Inspectors look for stocked, accessible handwashing sinks, staff washing hands when required, hair restraints, and sick employees being kept away from food. Gaps here can spread illness quickly.

    Recorded 3 times across 3 separate inspections, most recently on June 29, 2026. For example: Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 3 times across 3 separate inspections, most recently on February 12, 2026. For example: Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer

  • Chemicals and toxic substancesHigher risk

    Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.

    Recorded 2 times across 2 separate inspections, most recently on November 28, 2025. For example: Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)

  • Equipment and utensilsLower risk

    Equipment has to be built from cleanable materials, kept in good repair and stored properly. These findings are mostly about upkeep, like a cracked shelf, a worn gasket or utensils stored the wrong way. They are generally lower risk but show how well the kitchen is maintained.

    Recorded 3 times across 3 separate inspections, most recently on June 29, 2026. For example: Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning

About this data

These results come from Durham Region Health Department, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

8 inspections

  1. Routine

    4 infractions

    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food protected from potential contamination and/or adulteration
      • * Fail to protect food from contamination and/or adulteration
      • Operator to ensure all foods are covered in storage
      • Operator to ensure all foods are stored off the floor
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning freezer immediately. Do not store potentially hazardous foods in the unit until it is able to maintain foods in a frozen state.
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  2. Re-Inspection

    0 infractions

  3. Routine

    3 infractions

    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food protected from potential contamination and/or adulteration
      • * Observed potentially hazardous food not covered to prevent contamination / adulteration
      • Operator to ensure all foods are covered in storage
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to provide mechanical dishwasher in good repair
      • Operator to ensure mechanical dishwasher is maintained in good repair
  4. Re-Inspection

    2 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  5. Routine

    4 infractions

    • Food protected from potential contamination and/or adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Sanitary maintenance of and provision of required supplies in staff / public washroom facilities
      • * Fail to equip facility with hot and cold running water
      • Operator to ensure the washroom facilities are properly supplied with soap/detergent, single-service towels or hot air dryer, toilet paper and hot and cold running water
  6. Routine

    3 infractions

    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food protected from potential contamination and/or adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
  7. Re-Inspection

    0 infractions

  8. Routine

    2 infractions

    • Minimum of 1 Certified Food Handler per hour of operation?
      • * Fail to provide proof of a certified food handler certificate
      • Operator to provide proof of a certified food handler certificate
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to ensure utensils are manually sanitized after each mechanical wash cycle

Nearby inspected facilities

Own this business? Add a badge to your website