Skip to content
Loading map…

Eggsmart

2 710 Taunton Rd E, Whitby ON L1R 3L6 · Food Safety Inspections

4 inspections

  1. Routine

    1 infraction

    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
  2. Re-Inspection

    1 infraction

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
  3. Routine

    4 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to provide an appropriate test reagent to verify the concentration of the sanitizer
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  4. Routine

    1 infraction

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair