Skip to content
Loading map…

FAT BASTARD BURRITO

#7-255 King St N, WATERLOO ON N2J 4V2 · Facility

Inspection summary

FAT BASTARD BURRITO has been inspected 10 times by Region of Waterloo Public Health since November 25, 2024. The most recent inspection, on September 14, 2026, recorded 2 infractions.

1 of 10 inspections on record found no infractions at all. In the past 12 months there were 3 inspections with 10 infractions recorded. The higher-risk findings here relate to: Food temperature control, Protecting food from contamination and Cleaning and sanitizing.

Recent inspections have recorded fewer infractions than earlier ones, so the record is improving.

What these findings mean

Health authorities word their findings differently, so we group them by what they mean for your health. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Food temperature controlHigher risk

    Inspectors check that anything that has to be kept at a set temperature, such as chilled or hot food, or equipment like sterilizers, stays in its safe range and that accurate thermometers are on hand. With food, temperature problems are one of the most common causes of food poisoning.

    Recorded 9 times across 7 separate inspections, most recently on September 14, 2026. For example: Food is held at 4°C (40°F) or less

  • Protecting food from contaminationHigher risk

    This covers how food and supplies are stored and handled: kept covered, off the floor, and away from anything that could contaminate them. Where food is served, raw meat must be kept away from ready-to-eat food, a direct route for salmonella and E. coli.

    Recorded 7 times across 7 separate inspections, most recently on February 4, 2026. For example: Floors, walls, and ceilings clean and in good repair and maintained in a sanitary manner

  • Cleaning and sanitizingHigher risk

    Surfaces, dishes and tools that touch food or people must be cleaned and then sanitized or disinfected. Inspectors check sanitizer strength, dishwasher temperatures and how cleaning is done. Poor sanitizing lets germs survive from one use to the next.

    Recorded 6 times across 6 separate inspections, most recently on September 14, 2026. For example: Testing reagent used to determine concentration of sanitizer

  • PestsHigher risk

    Signs of mice, rats, cockroaches or flies, or gaps and clutter that let them get in or hide. Pests carry bacteria and can contaminate food, supplies and surfaces, so evidence of activity is treated seriously and usually triggers a follow-up visit.

    Recorded 3 times across 3 separate inspections, most recently on October 15, 2025. For example: Food premise is protected against the entry and harbouring of pests

  • Food safety training and certificationLower risk

    Many jurisdictions require a trained or certified person on site, such as a certified food handler. These findings mean the training record or the trained person was missing at the time. They do not by themselves mean anything was handled unsafely.

    Recorded 3 times across 2 separate inspections, most recently on February 4, 2026. For example: Separate hand washing basin provided for food handlers

About this data

These results come from Region of Waterloo Public Health, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

10 inspections

  1. Compliance Inspection

    2 infractions

    • Food is held at 4°C (40°F) or less
      • Ensure all hazardous foods are stored at 4°C (40°F) or less
    • Testing reagent used to determine concentration of sanitizer
      • Provide and use test reagent to determine concentration of sanitizer
  2. Compliance Inspection

    2 infractions

    • Food is held at 4°C (40°F) or less
      • Adjust or repair the refrigeration unit immediately. Do not store any hazardous foods in the unit until it is able to maintain hazardous foods at 4°C (40°F) or less
      • Ensure all hazardous foods are stored at 4°C (40°F) or less
    • Equipment, utensils, multi-service articles and all food contact surfaces are properly constructed and maintained
      • Ensure equipment, utensils and or multi-service articles in good repair
  3. Compliance Inspection

    6 infractions

    • Hot holding: minimum of 60°C (140°F) after cooking / rapid re-heating
      • Ensure food is held above 60°C (140°F) after cooking / rapid re-heating
    • Floors, walls, and ceilings clean and in good repair and maintained in a sanitary manner
      • Ensure floors are kept clean and in good repair
      • Ensure floors, walls, and ceilings are tight, smooth, and non-absorbent
    • Testing reagent used to determine concentration of sanitizer
      • Provide and use test reagent to determine concentration of sanitizer
    • Separate hand washing basin provided for food handlers
      • Hand washing station must be used only for hand washing of employees
      • Ensure hand washing basin is unobstructed and accessible for hand washing
    • Food handlers who come into contact with food/utensils do so in a sanitary manner
      • Ensure food handlers wash hands as often as necessary
    • Cloths and towels maintained in clean, good repair and not used for other purposes
      • Change sanitizing solution for wiping cloths at a minimum of every 2 hours, or as often as necessary, to maintain the solution clean and sanitary at all times
      • Provide sanitizing solution for wiping cloths/rinsing large utensils/rinsing food contact surfaces
  4. Compliance Inspection

    3 infractions

    • Food is held at 4°C (40°F) or less
      • Ensure all hazardous foods are stored at 4°C (40°F) or less
    • Floors, walls, and ceilings clean and in good repair and maintained in a sanitary manner
      • Cleaning required around, under, and behind kitchen equipment, counters, and baseboards
      • Ensure floors are kept clean and in good repair
      • Ensure floors, walls, and ceilings are tight, smooth, and non-absorbent
      • Ensure walls are kept clean and in good repair
    • Food premise is protected against the entry and harbouring of pests
      • Protect against entry, harbouring and breeding of pests
      • Provide tightly sealed entrances and / or screened entrances to prevent the entry of insects, birds, rodents, and other pests
  5. Re-inspection

    0 infractions

  6. Re-inspection

    5 infractions

    • The premises is operated and maintained free from potential/immediate health hazards
      • CLOSE FOOD PREMISES
      • Provide hot and cold running water under pressure where food is processed, prepared, manufactured or where utensils are cleaned
    • Food is held at 4°C (40°F) or less
      • Adjust or repair the refrigeration unit immediately. Do not store any hazardous foods in the unit until it is able to maintain hazardous foods at 4°C (40°F) or less
      • Ensure all hazardous foods are stored at 4°C (40°F) or less
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • Ensure wash water is between 60°C and 71°C
      • Ensure commercial NSF/ANSI dishwasher meets the Standard 3 certification
    • Floors, walls, and ceilings clean and in good repair and maintained in a sanitary manner
      • Cleaning required around, under, and behind kitchen equipment, counters, and baseboards
      • Ensure floors, walls, and ceilings are tight, smooth, and non-absorbent
    • Food premise is protected against the entry and harbouring of pests
      • Protect against entry, harbouring and breeding of pests
      • Provide tightly sealed entrances and / or screened entrances to prevent the entry of insects, birds, rodents, and other pests
  7. Compliance Inspection

    3 infractions

    • Food is held at 4°C (40°F) or less
      • Adjust or repair the refrigeration unit immediately. Do not store any hazardous foods in the unit until it is able to maintain hazardous foods at 4°C (40°F) or less
      • Ensure all hazardous foods are stored at 4°C (40°F) or less
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • Provide an easily readable thermometer for the dishwashing and sanitizing temperatures
    • Floors, walls, and ceilings clean and in good repair and maintained in a sanitary manner
      • Cleaning required around, under, and behind kitchen equipment, counters, and baseboards
      • Ensure floors are kept clean and in good repair
      • Ensure floors, walls, and ceilings are tight, smooth, and non-absorbent
  8. Re-inspection

    2 infractions

    • Floors, walls, and ceilings clean and in good repair and maintained in a sanitary manner
      • Cleaning required around, under, and behind kitchen equipment, counters, and baseboards
      • Ensure floors are kept clean and in good repair
      • Ensure floors, walls, and ceilings are tight, smooth, and non-absorbent
    • Equipment, utensils, multi-service articles and all food contact surfaces are properly constructed and maintained
      • Ensure equipment, utensils and or multi-service articles in good repair
      • Ensure equipment, utensils and or multi-service articles are cleaned and sanitized
      • Ensure food contact equipment and utensils are free from cracks, crevices and open seams
  9. Compliance Inspection

    4 infractions

    • Maintenance of sanitary facilities
      • Equip sanitary facility with a constant supply of hot and cold running water
    • Floors, walls, and ceilings clean and in good repair and maintained in a sanitary manner
      • Cleaning required around, under, and behind kitchen equipment, counters, and baseboards
      • Ensure floors are kept clean and in good repair
      • Ensure floors, walls, and ceilings are tight, smooth, and non-absorbent
    • Equipment, utensils, multi-service articles and all food contact surfaces are properly constructed and maintained
    • Food handlers who come into contact with food/utensils do so in a sanitary manner
      • Ensure food handlers wash hands as often as necessary
  10. Compliance Inspection

    4 infractions

    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
    • Testing reagent used to determine concentration of sanitizer
      • Provide and use test reagent to determine concentration of sanitizer
    • Floors, walls, and ceilings clean and in good repair and maintained in a sanitary manner
      • Ensure floors are kept clean and in good repair
    • Food premise is protected against the entry and harbouring of pests
      • Protect against entry, harbouring and breeding of pests
      • Provide tightly sealed entrances and / or screened entrances to prevent the entry of insects, birds, rodents, and other pests

Nearby inspected facilities

Own this business? Add a badge to your website