GINO'S TUSCANY PIZZERIA RESTAURANT
3968 HEMPSTEAD TURNPIKE, BETHPAGE, NY 11714 · Restaurant (Restaurant)
22 inspections
- Re-Inspection
0 infractions
- Inspection
7 infractions
- 10A: Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Not Critical Violation
- 5E: Enough refrigerated storage equipment is not present, properly designed, maintained or operated so that all potentially hazardous foods are cooled properly and stored below 45�F as required.
- Critical Violation
- 8A: Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Not Critical Violation
- 9B: Tobacco is used; eating, drinking in food preparation, dishwashing food storage areas
- Not Critical Violation
- 13A: Adequate, leakproof, non-absorbent, vermin-proof, covered containers not provided where needed
- Not Critical Violation
- 8E: Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Not Critical Violation
- 14B: Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Not Critical Violation
- 10A: Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Re-Inspection
0 infractions
- Re-Inspection
1 infraction
- 12C: Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Not Critical Violation
- 12C: Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Inspection
4 infractions
- 13A: Adequate, leakproof, non-absorbent, vermin-proof, covered containers not provided where needed
- Not Critical Violation
- 12C: Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Not Critical Violation
- 11D: Non food contact surfaces of equipment not clean
- Not Critical Violation
- 11A: Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Not Critical Violation
- 13A: Adequate, leakproof, non-absorbent, vermin-proof, covered containers not provided where needed
- Inspection
5 infractions
- 8F: Improper thawing procedures used
- Not Critical Violation
- 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Not Critical Violation
- 12A: Hot, cold running water not provided, pressure inadequate
- Not Critical Violation
- 8A: Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Not Critical Violation
- 11B: Wiping cloths dirty, not stored properly in sanitizing solutions
- Not Critical Violation
- 8F: Improper thawing procedures used
- Inspection
3 infractions
- 15A: Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Not Critical Violation
- 13A: Adequate, leakproof, non-absorbent, vermin-proof, covered containers not provided where needed
- Not Critical Violation
- 14B: Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Not Critical Violation
- 15A: Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Re-Inspection
0 infractions
- Inspection
6 infractions
- 2C: Cooked or prepared foods are subject to cross-contamination from raw foods.
- Critical Violation
- 1B: Water/ice: unsafe, unapproved sources, cross connections
- Critical Violation
- 3C: Food workers do not use proper utensils to eliminate bare hand contact with cooked or prepared foods.
- Critical Violation
- 9B: Tobacco is used; eating, drinking in food preparation, dishwashing food storage areas
- Not Critical Violation
- 8A: Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Not Critical Violation
- 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Not Critical Violation
- 2C: Cooked or prepared foods are subject to cross-contamination from raw foods.
- Re-Inspection
2 infractions
- 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Not Critical Violation
- 8B: In use food dispensing utensils improperly stored
- Not Critical Violation
- 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Inspection
7 infractions
- 14C: Pesticide application not supervised by a certified applicator
- Not Critical Violation
- 11B: Wiping cloths dirty, not stored properly in sanitizing solutions
- Not Critical Violation
- 4A: Toxic chemicals are improperly labeled, stored or used so that contamination of food can occur.
- Critical Violation
- 8D: Single service items reused, improperly stored, dispensed, not used when required
- Not Critical Violation
- 8A: Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Not Critical Violation
- 8B: In use food dispensing utensils improperly stored
- Not Critical Violation
- 10A: Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Not Critical Violation
- 14C: Pesticide application not supervised by a certified applicator
- Inspection
3 infractions
- 10A: Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Not Critical Violation
- 15B: Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Not Critical Violation
- 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Not Critical Violation
- 10A: Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Re-Inspection
0 infractions
- Inspection
3 infractions
- 5B: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
- Critical Violation
- 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Not Critical Violation
- 12E: Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Not Critical Violation
- 5B: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
- Inspection
5 infractions
- 11C: Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Not Critical Violation
- 10A: Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Not Critical Violation
- 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Not Critical Violation
- 12C: Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Not Critical Violation
- 13A: Adequate, leakproof, non-absorbent, vermin-proof, covered containers not provided where needed
- Not Critical Violation
- 11C: Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Inspection
4 infractions
- 1F: Shellfish not from approved sources, improperly tagged/labeled, tags not retained 90 days.
- Critical Violation
- 12E: Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Not Critical Violation
- 8E: Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Not Critical Violation
- 14B: Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Not Critical Violation
- 1F: Shellfish not from approved sources, improperly tagged/labeled, tags not retained 90 days.
- Inspection
4 infractions
- 4A: Toxic chemicals are improperly labeled, stored or used so that contamination of food can occur.
- Critical Violation
- 11A: Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Not Critical Violation
- 12E: Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Not Critical Violation
- 8F: Improper thawing procedures used
- Not Critical Violation
- 4A: Toxic chemicals are improperly labeled, stored or used so that contamination of food can occur.
- Inspection
4 infractions
- 10A: Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Not Critical Violation
- 2E: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
- Critical Violation
- 11D: Non food contact surfaces of equipment not clean
- Not Critical Violation
- 12C: Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Not Critical Violation
- 10A: Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Inspection
3 infractions
- 15A: Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Not Critical Violation
- 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Not Critical Violation
- 12E: Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Not Critical Violation
- 15A: Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Inspection
1 infraction
- 11D: Non food contact surfaces of equipment not clean
- Not Critical Violation
- 11D: Non food contact surfaces of equipment not clean
- Inspection
6 infractions
- 11A: Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Not Critical Violation
- 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Not Critical Violation
- 11B: Wiping cloths dirty, not stored properly in sanitizing solutions
- Not Critical Violation
- 4A: Toxic chemicals are improperly labeled, stored or used so that contamination of food can occur.
- Critical Violation
- 12C: Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Not Critical Violation
- 12E: Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Not Critical Violation
- 11A: Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Inspection
5 infractions
- 11A: Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Not Critical Violation
- 2E: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
- Critical Violation
- 11C: Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Not Critical Violation
- 12E: Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Not Critical Violation
- 12C: Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Not Critical Violation
- 11A: Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions