Skip to content
Loading map…

Jack and Joes

570 Longworth Ave, Bowmanville ON L1C 0H4 · Food Safety Inspections

11 inspections

  1. Routine

    1 infraction

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  2. Re-Inspection

    0 infractions

  3. Routine

    6 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
    • Food is prepared in a safe manner
      • * Fail to ensure food is prepared in a safe manner
      • Do not thaw hazardous foods at room temperature
    • Separate hand washing basin provided for food handlers
      • * Fail to ensure hand washing basin is easily accessible
      • Operator to ensure a designated hand washing basin is provided and/or accessible in each food preparation area
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to provide mechanical dishwasher in good repair
      • Operator to ensure utensils are manually sanitized after each mechanical wash cycle
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  4. Routine

    2 infractions

    • Separate hand washing basin provided for food handlers
      • * Fail to ensure hand washing basin is easily accessible
      • Operator to ensure a designated hand washing basin is provided and/or accessible in each food preparation area
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
  5. Re-Inspection

    0 infractions

  6. Routine

    11 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
    • Thermometers used to verify food preparation and storage temperatures
      • * Fail to provide thermometer in temperature controlled room / equipment used to store potentially hazardous foods
      • Operator to provide accurate and easily readable indicating thermometers in temperature controlled rooms/equipment used for storage of potentially hazardous foods
    • Food is prepared in a safe manner
      • * Fail to ensure food is prepared in a safe manner
      • Do not thaw hazardous foods at room temperature
      • Observed potentially hazardous foods not being thawed in an appropriate and safe manner
    • Washing hands thoroughly before and after handling food
      • * Food handlers fail to wash hands as often as necessary to prevent the contamination of food or food areas
      • Food handlers must wash hands after they are contaminated and before handling food
      • Operator to wash hands before putting on disposable gloves
    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food protected from potential contamination and/or adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to ensure utensils are manually sanitized after each mechanical wash cycle
      • Operator to ensure mechanical dishwasher is maintained in good repair
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
      • Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  7. Re-Inspection

    0 infractions

  8. Routine

    4 infractions

    • Thermometers used to verify food preparation and storage temperatures
      • * Fail to provide easily readable thermometer
      • Operator to provide accurate and easily readable indicating thermometers in temperature controlled rooms/equipment used for storage of potentially hazardous foods
    • Food protected from potential contamination and/or adulteration
      • * Observed potentially hazardous food not covered to prevent contamination / adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure all foods are covered in storage
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to maintain a written record of pest control measures taken for 1 year
      • Operator to ensure written records are maintained for 1 year
  9. Re-Inspection

    0 infractions

  10. Complaint

    1 infraction

    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to prevent the entrance of insect / rodent / pest
      • Operator to ensure food premise shall be protected against the entry of pest
  11. Routine & Complaint

    3 infractions

    • Thermometers used to verify food preparation and storage temperatures
      • * Fail to provide easily readable thermometer
      • Operator to provide accurate and easily readable indicating thermometers in temperature controlled rooms/equipment used for storage of potentially hazardous foods
    • Food protected from potential contamination and/or adulteration
      • * Observed potentially hazardous food not covered to prevent contamination / adulteration
      • Operator to ensure all foods are covered in storage
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair