Skip to content
Loading map…

Lagos Kitchen

432 Simcoe St S, Oshawa ON L1H 4J6 · Food Safety Inspections

9 inspections

  1. Re-Inspection

    0 infractions

  2. Routine

    4 infractions

    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Floors clean and in good repair
      • * Fail to ensure floor of food-handling room kept clean and in good repair
      • Operator to ensure floors are kept clean and in good repair
  3. Routine

    3 infractions

    • All foods at the premises are from an inspected source
      • *Fail to ensure records of food purchases are retained at the premise for 1 year
      • Operator to ensure records of food purchases are retained at the premise for 1 year
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Observe containers/coverings/wrappings used that are not food grade
      • Operator to ensure all food containers/coverings/wrappings are made from food-grade materials
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  4. Routine

    3 infractions

    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • CCP monitoring should be conducted by operator
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  5. Routine

    2 infractions

    • Food protected from potential contamination and/or adulteration
      • * Observed foods stored in containers that cannot be readily cleaned and sanitized
      • Operator to ensure all food is properly stored, displayed, transported and served to prevent contamination
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
      • Operator to ensure written records are maintained for 1 year
      • Operator to ensure food premise shall be protected against the entry of pest
  6. Re-Inspection

    2 infractions

    • All foods at the premises are from an inspected source
      • * Fail to ensure food offered for sale or used for preparation is from an approved / inspected source
      • Operator to use food only from approved / inspected sources
      • Operator to ensure records of food purchases are retained at the premise for 1 year
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
      • Operator to ensure written records are maintained for 1 year
      • Operator to ensure food premise shall be protected against the entry of pest
      • Provide proof of contract with licensed pest control operator to control and remove insect/pest infestation
  7. Routine

    4 infractions

    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
    • All foods at the premises are from an inspected source
      • *Fail to ensure records of food purchases are retained at the premise for 1 year
      • Operator to use food only from approved / inspected sources
      • Operator to ensure records of food purchases are retained at the premise for 1 year
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of significant pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
      • Operator to ensure written records are maintained for 1 year
      • Operator to ensure food premise shall be protected against the entry of pest
      • Provide proof of contract with licensed pest control operator to control and remove insect/pest infestation
    • The premises is maintained free from every SERIOUS condition that may be a health hazard, adversely affecting the sanitary operation of the premises or adversely affecting the wholesomeness of the food
      • Observed significant insect/rodent infestation
      • Operator to operate and maintain premise free from every condition that may be a health hazard
  8. Re-Inspection

    0 infractions

  9. Routine

    6 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • CCP monitoring should be conducted by operator
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food protected from potential contamination and/or adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to properly store food in food grade storage bags/containers
      • Operator to ensure all food containers/coverings/wrappings are made from food-grade materials
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair