Skip to content
Loading map…

Los Cabos Cantina & Grill

1009 Dundas St E, Whitby ON L1N 2K4 · Food Safety Inspections

Official record from Durham Region →

Inspection summary

Los Cabos Cantina & Grill has been inspected 5 times by Durham Region Health Department since November 7, 2024. The most recent inspection, on August 18, 2026, recorded 1 infraction.

None of the 5 inspections on record were free of infractions. In the past 12 months there were 3 inspections with 7 infractions recorded. The higher-risk findings here relate to: Pests, Food temperature control and Cleaning and sanitizing.

The number of infractions per inspection has stayed roughly the same over time.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • PestsHigher risk

    Signs of mice, rats, cockroaches or flies, or gaps and clutter that let them get in or hide. Pests carry bacteria and can contaminate food and surfaces, so evidence of activity is treated seriously and usually triggers a follow-up visit.

    Recorded 2 times across 2 separate inspections, most recently on May 12, 2026. For example: Adequate protection against the entrance of insects, vermin, and rodents

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 2 times across 2 separate inspections, most recently on December 10, 2025. For example: Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating

  • Cleaning and sanitizingHigher risk

    Anything that touches food, such as cutting boards, dishes and utensils, must be washed, rinsed and sanitized. Inspectors check dishwasher temperatures, sanitizer strength and how wiping cloths are stored. Poor sanitizing lets bacteria survive from one use to the next.

    Recorded once on November 7, 2024. For example: Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred

  • Equipment and utensilsLower risk

    Equipment has to be built from cleanable materials, kept in good repair and stored properly. These findings are mostly about upkeep, like a cracked shelf, a worn gasket or utensils stored the wrong way. They are generally lower risk but show how well the kitchen is maintained.

    Recorded 4 times across 4 separate inspections, most recently on May 12, 2026. For example: Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning

  • Building, plumbing and upkeepLower risk

    Floors, walls and ceilings must be smooth and clean, with working lighting, ventilation, plumbing, hot and cold water, and washrooms. These are rarely an immediate food-safety risk on their own, but persistent problems can lead to pest or sanitation issues.

    Recorded 2 times across 2 separate inspections, most recently on August 18, 2026. For example: Floors clean and in good repair

About this data

These results come from Durham Region Health Department, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

5 inspections

  1. Complaint

    1 infraction

    • Floors clean and in good repair
      • * Fail to ensure floor of food-handling room kept clean and in good repair
      • Operator to ensure floors are kept clean and in good repair
  2. Routine

    3 infractions

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to prevent the entrance of insect / rodent / pest
      • Operator to ensure food premise shall be protected against the entry of pest
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  3. Routine

    3 infractions

    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to prevent the entrance of insect / rodent / pest
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
      • Operator to ensure food premise shall be protected against the entry of pest
  4. Routine

    2 infractions

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to provide an appropriate test reagent to verify the concentration of the sanitizer
  5. Routine

    2 infractions

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
      • Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
      • Operator to ensure wiping cloths are handled properly (sanitizing solution used)

Nearby inspected facilities

Own this business? Add a badge to your website