Skip to content
Loading map…

Maimana Naan & Kabab

7 279 Kingston Rd E, Ajax ON L1Z 0K5 · Food Safety Inspections

Official record from Durham Region →

Inspection summary

Maimana Naan & Kabab has been inspected 8 times by Durham Region Health Department since January 3, 2025. The most recent inspection, on September 18, 2026, recorded 3 infractions.

1 of 8 inspections on record found no infractions at all. In the past 12 months there were 3 inspections with 6 infractions recorded. The higher-risk findings here relate to: Food temperature control, Pests and Chemicals and toxic substances.

The number of infractions per inspection has stayed roughly the same over time.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 4 times across 3 separate inspections, most recently on September 18, 2026. For example: Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer

  • PestsHigher risk

    Signs of mice, rats, cockroaches or flies, or gaps and clutter that let them get in or hide. Pests carry bacteria and can contaminate food and surfaces, so evidence of activity is treated seriously and usually triggers a follow-up visit.

    Recorded 3 times across 3 separate inspections, most recently on September 10, 2025. For example: Adequate protection against the entrance of insects, vermin, and rodents

  • Chemicals and toxic substancesHigher risk

    Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.

    Recorded once on January 6, 2026. For example: Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)

  • Cleaning and sanitizingHigher risk

    Anything that touches food, such as cutting boards, dishes and utensils, must be washed, rinsed and sanitized. Inspectors check dishwasher temperatures, sanitizer strength and how wiping cloths are stored. Poor sanitizing lets bacteria survive from one use to the next.

    Recorded once on September 10, 2025. For example: Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred

  • Equipment and utensilsLower risk

    Equipment has to be built from cleanable materials, kept in good repair and stored properly. These findings are mostly about upkeep, like a cracked shelf, a worn gasket or utensils stored the wrong way. They are generally lower risk but show how well the kitchen is maintained.

    Recorded 3 times across 3 separate inspections, most recently on June 25, 2026. For example: Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning

About this data

These results come from Durham Region Health Department, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

8 inspections

  1. Routine

    3 infractions

    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
    • Walls clean and in good repair
      • * Fail to ensure walls of food premise kept clean and in good repair
      • Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
    • Ceilings clean and in good repair
      • * Fail to ensure ceiling of food premise kept clean and in good repair
      • Operator to ensure ceiling of the food premise is maintained in a sanitary condition and in good repair
  2. Routine

    2 infractions

    • Separate hand washing basin provided for food handlers
      • * Fail to use basin only for hand washing of employees
      • Operator to ensure designated hand washing basin is only used for hand washing
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  3. Routine

    1 infraction

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
  4. Re-Inspection

    1 infraction

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
  5. Re-Inspection

    0 infractions

  6. Routine

    5 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Operator to ensure utensils are manually sanitized after each mechanical wash cycle
      • Operator to ensure the appropriate chemicals and/or temperatures are used for proper washing and sanitizing
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure food contact surfaces are cleaned & sanitized after each use or as often as necessary
      • Operator to ensure all food contact surfaces are properly cleaned & sanitized
      • Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to maintain a written record of pest control measures taken for 1 year
      • Operator to ensure written records are maintained for 1 year
  7. Routine

    1 infraction

    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
  8. Routine

    2 infractions

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
      • Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to prevent the entrance of insect / rodent / pest
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
      • Operator to ensure food premise shall be protected against the entry of pest

Nearby inspected facilities

Own this business? Add a badge to your website