Skip to content
Loading map…

Ontario Shores - Lakeview Cafeteria/Serveries

700 Gordon St, Whitby ON L1N 5S9 · Food Safety Inspections

Official record from Durham Region →

Inspection summary

Ontario Shores - Lakeview Cafeteria/Serveries has been inspected 7 times by Durham Region Health Department since November 28, 2024. The most recent inspection, on July 23, 2026, found no infractions.

1 of 7 inspections on record found no infractions at all. In the past 12 months there were 4 inspections with 8 infractions recorded. The higher-risk findings here relate to: Food temperature control, Protecting food from contamination and Chemicals and toxic substances.

The number of infractions per inspection has stayed roughly the same over time.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 4 times across 4 separate inspections, most recently on July 9, 2026. For example: Potentially hazardous food is held at 4°C (40°F) or lower

  • Protecting food from contaminationHigher risk

    This covers how food is stored, prepared and displayed: raw meat kept away from ready-to-eat food, food covered and stored off the floor, and nothing dripping or splashing into it. Cross-contamination from raw to cooked food is a direct route for salmonella and E. coli.

    Recorded 3 times across 3 separate inspections, most recently on November 27, 2025. For example: Food protected from potential contamination and/or adulteration

  • Chemicals and toxic substancesHigher risk

    Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.

    Recorded once on July 9, 2026. For example: Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)

  • Handwashing and staff hygieneHigher risk

    Hands are the main way germs like norovirus move from people to food. Inspectors look for stocked, accessible handwashing sinks, staff washing hands when required, hair restraints, and sick employees being kept away from food. Gaps here can spread illness quickly.

    Recorded once on November 28, 2024. For example: Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels

  • Equipment and utensilsLower risk

    Equipment has to be built from cleanable materials, kept in good repair and stored properly. These findings are mostly about upkeep, like a cracked shelf, a worn gasket or utensils stored the wrong way. They are generally lower risk but show how well the kitchen is maintained.

    Recorded 5 times across 5 separate inspections, most recently on July 9, 2026. For example: Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning

About this data

These results come from Durham Region Health Department, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

7 inspections

  1. Re-Inspection

    0 infractions

  2. Routine

    3 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • * Fail to maintain all equipment/non-food contact surfaces are of sound and tight construction
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
  3. Routine

    2 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • * Fail to maintain all equipment/non-food contact surfaces are of sound and tight construction
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
  4. Routine

    3 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
    • Food protected from potential contamination and/or adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  5. Routine

    3 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
    • Food protected from potential contamination and/or adulteration
      • * Fail to protect food from contamination and/or adulteration
      • Operator to ensure all foods are covered in storage
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
  6. Routine

    2 infractions

    • Food protected from potential contamination and/or adulteration
      • * Fail to protect food from contamination and/or adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure cooked and ready-to-eat foods are separated and above raw foods when handled or stored
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  7. Routine

    1 infraction

    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied

Nearby inspected facilities

Own this business? Add a badge to your website