Skip to content
Loading map…

Oshawa Golf and Curling Club

160 Alexandra St, Oshawa ON L1G 2C4 · Food Safety Inspections

Official record from Durham Region →

Inspection summary

Oshawa Golf and Curling Club has been inspected 9 times by Durham Region Health Department since December 16, 2024. The most recent inspection, on August 12, 2026, recorded 4 infractions.

1 of 9 inspections on record found no infractions at all. In the past 12 months there were 6 inspections with 14 infractions recorded. The higher-risk findings here relate to: Chemicals and toxic substances, Pests and Food temperature control.

The number of infractions per inspection has stayed roughly the same over time.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Chemicals and toxic substancesHigher risk

    Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.

    Recorded 4 times across 4 separate inspections, most recently on August 12, 2026. For example: Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)

  • PestsHigher risk

    Signs of mice, rats, cockroaches or flies, or gaps and clutter that let them get in or hide. Pests carry bacteria and can contaminate food and surfaces, so evidence of activity is treated seriously and usually triggers a follow-up visit.

    Recorded 3 times across 3 separate inspections, most recently on August 12, 2026. For example: Adequate protection against the entrance of insects, vermin, and rodents

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 2 times across 2 separate inspections, most recently on March 12, 2026. For example: Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer

  • Equipment and utensilsLower risk

    Equipment has to be built from cleanable materials, kept in good repair and stored properly. These findings are mostly about upkeep, like a cracked shelf, a worn gasket or utensils stored the wrong way. They are generally lower risk but show how well the kitchen is maintained.

    Recorded 7 times across 7 separate inspections, most recently on August 12, 2026. For example: Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning

  • Building, plumbing and upkeepLower risk

    Floors, walls and ceilings must be smooth and clean, with working lighting, ventilation, plumbing, hot and cold water, and washrooms. These are rarely an immediate food-safety risk on their own, but persistent problems can lead to pest or sanitation issues.

    Recorded 3 times across 3 separate inspections, most recently on August 12, 2026. For example: Floors clean and in good repair

About this data

These results come from Durham Region Health Department, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

9 inspections

  1. Routine

    4 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
      • Operator to ensure all food contact surfaces/equipment/utensils/multi-service articles are made of materials that can be readily cleaned and sanitized
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
      • Operator to ensure food premise shall be protected against the entry of pest
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  2. Complaint

    2 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  3. Routine

    0 infractions

  4. Re-Inspection

    2 infractions

    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Hot water sanitizer must be at 82°C or greater for at least 10 seconds
    • Adequate protection against the entrance of insects, vermin, and rodents
  5. Routine

    3 infractions

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Hot water sanitizer must be at 82°C or greater for at least 10 seconds
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to maintain a written record of pest control measures taken for 1 year
      • * Evidence of pests observed
      • Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
      • Operator to ensure written records are maintained for 1 year
  6. Routine

    3 infractions

    • Separate hand washing basin provided for food handlers
      • * Fail to ensure hand washing basin is easily accessible
      • Operator to ensure a designated hand washing basin is provided and/or accessible in each food preparation area
      • Operator to ensure designated hand washing basin is only used for hand washing
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  7. Routine

    2 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  8. Routine

    1 infraction

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  9. Routine

    3 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Floors clean and in good repair
      • * Fail to ensure floor of food-handling room kept clean and in good repair
      • Operator to ensure floors are kept clean and in good repair

Nearby inspected facilities

Own this business? Add a badge to your website