Skip to content
Loading map…

Sankalp - The Taste of India

5 & 6 452 Taunton Rd W, Oshawa ON L1L 0W1 · Food Safety Inspections

10 inspections

  1. Re-Inspection

    0 infractions

  2. Routine

    5 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure filters in the ventilation system are maintained in a clean and sanitary manner
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to prevent the entrance of insect / rodent / pest
      • Operator to ensure food premise shall be protected against the entry of pest
    • Floors clean and in good repair
      • * Fail to ensure floor of dishwashing area kept clean and in good repair
      • Operator to ensure floors are kept clean and in good repair
    • Walls clean and in good repair
      • * Fail to ensure walls of food premise kept clean and in good repair
      • Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
  3. Re-Inspection

    3 infractions

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to prevent the entrance of insect / rodent / pest
      • Operator to ensure food premise shall be protected against the entry of pest
    • Floors clean and in good repair
      • * Fail to ensure floor of dishwashing area kept clean and in good repair
      • Operator to ensure floors are kept clean and in good repair
  4. Routine

    9 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food protected from potential contamination and/or adulteration
      • * Observed foods stored in containers that cannot be readily cleaned and sanitized
      • Operator to ensure all food is properly stored, displayed, transported and served to prevent contamination
    • Toxic / poisonous substances (chemicals / pesticides) to be stored separately from food
      • * Fail to keep toxic / poisonous substance in container bearing identifying label
      • Operator to ensure toxic/poisonous substances are stored in a manner preventing contamination
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • * Fail to ensure filters in the ventilation system are maintained in a clean and sanitary manner
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure filters in the ventilation system are maintained in a clean and sanitary manner
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to prevent the entrance of insect / rodent / pest
      • Operator to ensure food premise shall be protected against the entry of pest
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
    • Walls clean and in good repair
      • * Fail to ensure walls of food premise kept clean and in good repair
      • Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
  5. Re-Inspection

    3 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
      • Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  6. Re-Inspection

    3 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
  7. Routine

    4 infractions

    • Washing hands thoroughly before and after handling food
      • * Food handlers fail to wash hands as often as necessary to prevent the contamination of food or food areas
      • Operator to wash hands before putting on disposable gloves
    • Separate hand washing basin provided for food handlers
      • * Fail to ensure hand washing basin is easily accessible
      • Operator to ensure designated hand washing basin is only used for hand washing
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • * Fail to ensure filters in the ventilation system are maintained in a clean and sanitary manner
      • Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure filters in the ventilation system are maintained in a clean and sanitary manner
    • Floors clean and in good repair
      • * Fail to ensure floor of dishwashing area kept clean and in good repair
      • Operator to ensure floors are kept clean and in good repair
  8. Re-Inspection

    0 infractions

  9. Routine

    4 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
      • Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
    • Walls clean and in good repair
      • * Fail to ensure walls of food premise kept clean and in good repair
      • Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
  10. Routine

    2 infractions

    • Separate hand washing basin provided for food handlers
      • * Fail to use basin only for hand washing of employees
      • Operator to ensure designated hand washing basin is only used for hand washing
    • Food protected from potential contamination and/or adulteration
      • * Observed potentially hazardous food not covered to prevent contamination / adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure all foods are covered in storage