Skip to content
Loading map…

The Corner House Pub & Grill

104 Brock St W, Uxbridge ON L9P 1P4 · Food Safety Inspections

Official record from Durham Region →

Inspection summary

The Corner House Pub & Grill has been inspected 8 times by Durham Region Health Department since November 12, 2024. The most recent inspection, on October 15, 2026, recorded 2 infractions.

None of the 8 inspections on record were free of infractions. In the past 12 months there were 5 inspections with 9 infractions recorded. The higher-risk findings here relate to: Food temperature control, Chemicals and toxic substances and Protecting food from contamination.

The number of infractions per inspection has stayed roughly the same over time.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 2 times across 2 separate inspections, most recently on March 3, 2026. For example: Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating

  • Chemicals and toxic substancesHigher risk

    Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.

    Recorded 2 times across 2 separate inspections, most recently on April 7, 2025. For example: Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)

  • Protecting food from contaminationHigher risk

    This covers how food is stored, prepared and displayed: raw meat kept away from ready-to-eat food, food covered and stored off the floor, and nothing dripping or splashing into it. Cross-contamination from raw to cooked food is a direct route for salmonella and E. coli.

    Recorded once on August 22, 2026. For example: Food protected from potential contamination and/or adulteration

  • Equipment and utensilsLower risk

    Equipment has to be built from cleanable materials, kept in good repair and stored properly. These findings are mostly about upkeep, like a cracked shelf, a worn gasket or utensils stored the wrong way. They are generally lower risk but show how well the kitchen is maintained.

    Recorded 6 times across 6 separate inspections, most recently on October 15, 2026. For example: Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning

  • Building, plumbing and upkeepLower risk

    Floors, walls and ceilings must be smooth and clean, with working lighting, ventilation, plumbing, hot and cold water, and washrooms. These are rarely an immediate food-safety risk on their own, but persistent problems can lead to pest or sanitation issues.

    Recorded 2 times across 2 separate inspections, most recently on December 2, 2025. For example: Floors clean and in good repair

About this data

These results come from Durham Region Health Department, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

8 inspections

  1. Routine

    2 infractions

    • Washing hands thoroughly before and after handling food
      • * Food handlers fail to wash hands as often as necessary to prevent the contamination of food or food areas
      • Operator to wash hands before putting on disposable gloves
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  2. Routine

    2 infractions

    • Food protected from potential contamination and/or adulteration
      • * Observed potentially hazardous food not covered to prevent contamination / adulteration
      • Operator to ensure all food is properly stored, displayed, transported and served to prevent contamination
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • * Fail to ensure filters in the ventilation system are maintained in a clean and sanitary manner
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure filters in the ventilation system are maintained in a clean and sanitary manner
  3. Re-Inspection

    1 infraction

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
  4. Routine

    2 infractions

    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • CCP monitoring should be conducted by operator
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
  5. Routine

    2 infractions

    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  6. Routine

    1 infraction

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  7. Routine

    2 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to provide utensils and/or multi-service food containers/multi-service articles that can be readily cleaned and sanitized
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
      • Operator to ensure all food contact surfaces/equipment/utensils/multi-service articles are made of materials that can be readily cleaned and sanitized
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • * Fail to maintain all equipment/non-food contact surfaces are of sound and tight construction
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  8. Routine

    2 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces/equipment/utensils/multi-service articles are made of materials that are corrosion resistant/non-toxic/non-absorbent
    • Lighting adequate for food preparation and cleaning
      • * Fail to provide adequate lighting for food preparation and cleaning
      • Provide adequate lighting for food preparation and cleaning

Nearby inspected facilities

Own this business? Add a badge to your website