Atrangi
1&2 3100 Brock St N, Whitby ON L1R 3J7 · Food Safety Inspections
11 inspections
- Routine
4 infractions
- Potentially hazardous food is held at 4°C (40°F) or lower
- * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
- Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
- Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
- Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
- * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
- Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
- Operator to ensure utensils are manually sanitized after each mechanical wash cycle
- Manual dishwashing: Wash, rinse, sanitize technique
- * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
- Quaternary ammonium compound must be at least 200 parts per million and lower than 24°C or more for at least 45 seconds
- Potentially hazardous food is held at 4°C (40°F) or lower
- Re-Inspection
0 infractions
- Re-Inspection
1 infraction
- Adequate protection against the entrance of insects, vermin, and rodents
- * Fail to prevent the entrance of insect / rodent / pest
- Operator to ensure food premise shall be protected against the entry of pest
- Adequate protection against the entrance of insects, vermin, and rodents
- Routine
8 infractions
- Thermometers used to verify food preparation and storage temperatures
- * Fail to provide thermometer in temperature controlled room / equipment used to store potentially hazardous foods
- Operator to provide accurate and easily readable indicating thermometers in temperature controlled rooms/equipment used for storage of potentially hazardous foods
- Separate hand washing basin provided for food handlers
- * Fail to ensure hand washing basin is easily accessible
- Operator to ensure a designated hand washing basin is provided and/or accessible in each food preparation area
- Food protected from potential contamination and/or adulteration
- * Observed potentially hazardous food not covered to prevent contamination / adulteration
- * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
- Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
- Operator to ensure all foods are covered in storage
- Toxic / poisonous substances (chemicals / pesticides) to be stored separately from food
- * Fail to keep toxic / poisonous substance in container bearing identifying label
- Operator to ensure toxic/poisonous substances are stored in a manner preventing contamination
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to use equipment/utensils/dishes/food containers/multi-service articles that are corrosion resistant/non-toxic/non-absorbent
- Operator to ensure all food contact surfaces/equipment/utensils/multi-service articles are made of materials that are corrosion resistant/non-toxic/non-absorbent
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- * Fail to ensure filters in the ventilation system are maintained in a clean and sanitary manner
- Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
- Operator to maintain table covers/napkins/serviettes in clean and in good repair
- Operator to ensure filters in the ventilation system are maintained in a clean and sanitary manner
- Adequate protection against the entrance of insects, vermin, and rodents
- * Fail to prevent the entrance of insect / rodent / pest
- * Evidence of pests observed
- Contact licensed pest control operator for insect / rodent / pest treatment and control
- Operator to ensure food premise shall be protected against the entry of pest
- Walls clean and in good repair
- * Fail to ensure walls of food premise kept clean and in good repair
- Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
- Thermometers used to verify food preparation and storage temperatures
- Routine
2 infractions
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- Re-Inspection
1 infraction
- Floors clean and in good repair
- * Fail to ensure floor of dishwashing area kept clean and in good repair
- Operator to ensure floors are kept clean and in good repair
- Floors clean and in good repair
- Routine
9 infractions
- Washing hands thoroughly before and after handling food
- * Food handlers fail to wash hands as often as necessary to prevent the contamination of food or food areas
- Operator to wash hands before putting on disposable gloves
- Separate hand washing basin provided for food handlers
- * Fail to use basin only for hand washing of employees
- Operator to ensure designated hand washing basin is only used for hand washing
- Food protected from potential contamination and/or adulteration
- * Observed potentially hazardous food not covered to prevent contamination / adulteration
- * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
- Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
- Operator to ensure all foods are covered in storage
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
- Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
- * Fail to ensure food contact surfaces are cleaned & sanitized after each use or as often as necessary
- Operator to ensure all food contact surfaces are properly cleaned & sanitized
- Floors clean and in good repair
- * Fail to ensure floor of dishwashing area kept clean and in good repair
- * Fail to ensure floors of food premise are kept clean and/or in good repair
- Operator to ensure floors are kept clean and in good repair
- Walls clean and in good repair
- * Fail to ensure walls of food premise kept clean and in good repair
- Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
- General housekeeping is satisfactory
- * Fail to arrange furniture, equipment and appliances as to permit thorough cleaning and the maintaining of the room or place in a clean and sanitary condition
- Operator to ensure the furniture, equipment and appliances are arranged to permit thorough cleaning and the maintaining of the room or place in a clean and sanitary condition
- Washing hands thoroughly before and after handling food
- Re-Inspection
0 infractions
- Routine
4 infractions
- Thermometers used to verify food preparation and storage temperatures
- * Fail to provide easily readable thermometer
- * Fail to use accurate thermometer to check storage temperature of potentially hazardous food
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
- * Fail to ensure food contact surfaces are cleaned & sanitized after each use or as often as necessary
- Operator to ensure all food contact surfaces are properly cleaned & sanitized
- Floors clean and in good repair
- * Fail to ensure floors of food premise are kept clean and/or in good repair
- Operator to ensure floors are kept clean and in good repair
- Thermometers used to verify food preparation and storage temperatures
- Re-Inspection
2 infractions
- Adequate protection against the entrance of insects, vermin, and rodents
- * Evidence of pests observed
- Operator to ensure food premise shall be protected against the entry of pest
- Floors clean and in good repair
- * Fail to ensure floor of food-handling room kept clean and in good repair
- Operator to ensure floors are kept clean and in good repair
- Adequate protection against the entrance of insects, vermin, and rodents
- Routine
10 infractions
- Washing hands thoroughly before and after handling food
- * Food handlers fail to wash hands as often as necessary to prevent the contamination of food or food areas
- Operator to wash hands before putting on disposable gloves
- Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
- * Fail to provide hot and cold water for hand washing in food preparation area
- * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
- Operator to ensure hand washing basins are adequately supplied
- Food protected from potential contamination and/or adulteration
- * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
- Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
- Constant supply of hot and cold running water under pressure
- * Fail to provide premise with hot and/or cold water
- Operator to ensure hot and cold running water under pressure is provided
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Adequate protection against the entrance of insects, vermin, and rodents
- * Evidence of pests observed
- Contact licensed pest control operator for insect / rodent / pest treatment and control
- Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
- Provide proof of contract with licensed pest control operator to control and remove insect/pest infestation
- Floors clean and in good repair
- * Fail to ensure floor of food-handling room kept clean and in good repair
- Operator to ensure floors are kept clean and in good repair
- Walls clean and in good repair
- * Fail to ensure walls of food premise kept clean and in good repair
- Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
- The premises is maintained free from every SERIOUS condition that may be a health hazard, adversely affecting the sanitary operation of the premises or adversely affecting the wholesomeness of the food
- Fail to provide premise with hot and/or cold water under pressure
- Washing hands thoroughly before and after handling food