Skip to content
Loading map…

Bollocks Pub & Kitchen

1 30 Taunton Rd E, Whitby ON L1R 0A1 · Food Safety Inspections

6 inspections

  1. Re-Inspection

    1 infraction

    • Walls clean and in good repair
      • * Fail to ensure walls of food premise kept clean and in good repair
      • Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
  2. Routine

    4 infractions

    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Operator to ensure mechanical dishwasher is maintained in good repair
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Fail to prevent the entrance of insect / rodent / pest
      • Operator to ensure food premise shall be protected against the entry of pest
  3. Routine

    0 infractions

  4. Routine

    1 infraction

    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to ensure utensils are manually sanitized after each mechanical wash cycle
  5. Re-Inspection

    0 infractions

  6. Routine

    4 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to ensure utensils are manually sanitized after each mechanical wash cycle
    • Sanitary maintenance of and provision of required supplies in staff / public washroom facilities
      • * Fail to equip facility with a method of hand drying that uses single-service towels or a hot air dryer
      • Operator to ensure the washroom facilities are properly supplied with soap/detergent, single-service towels or hot air dryer, toilet paper and hot and cold running water
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control