Swiss Chalet
50 Taunton Rd E, Whitby ON L1R 3L5 · Food Safety Inspections
7 inspections
- Routine
1 infraction
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- Re-Inspection & Complaint
2 infractions
- Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
- * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
- Operator to ensure hand washing basins are adequately supplied
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to ensure filters in the ventilation system are maintained in a clean and sanitary manner
- Operator to ensure filters in the ventilation system are maintained in a clean and sanitary manner
- Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
- Routine
2 infractions
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Floors clean and in good repair
- * Fail to ensure floor of food-handling room kept clean and in good repair
- Operator to ensure floors are kept clean and in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- Routine
1 infraction
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- Routine & Complaint
3 infractions
- Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
- * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
- Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
- Food protected from potential contamination and/or adulteration
- * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
- Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
- Floors clean and in good repair
- * Fail to ensure floor of food-handling room kept clean and in good repair
- Operator to ensure floors are kept clean and in good repair
- Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
- Routine
1 infraction
- Separate hand washing basin provided for food handlers
- * Fail to use basin only for hand washing of employees
- Operator to ensure designated hand washing basin is only used for hand washing
- Separate hand washing basin provided for food handlers
- Routine
2 infractions
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
- * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
- Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning