Skip to content
Loading map…

Chingari Indian Restaurant

105 30 Broadleaf Ave, Whitby ON L1R 0B5 · Food Safety Inspections

9 inspections

  1. Re-Inspection

    0 infractions

  2. Routine

    6 infractions

    • Food handler (does not use tobacco while handling food, has clean outer garments, good personal hygiene, hair confined, free from infectious agent of a disease/skin disease, submit medical exams and tests as required)
      • * Food handler fail to take reasonable precautions to ensure that food is not contaminated by hair
      • Operator to ensure food handler’s hair is properly confined while handling food
    • Toxic / poisonous substances (chemicals / pesticides) to be stored separately from food
      • * Fail to keep toxic / poisonous substance in container bearing identifying label
      • Operator to ensure toxic/poisonous substances are stored in a manner preventing contamination
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Sanitary maintenance of and provision of required supplies in staff / public washroom facilities
      • * Fail to equip facility with a method of hand drying that uses single-service towels or a hot air dryer
      • Operator to ensure the washroom facilities are properly supplied with soap/detergent, single-service towels or hot air dryer, toilet paper and hot and cold running water
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  3. Routine

    1 infraction

    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
  4. Routine

    1 infraction

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Observe containers/coverings/wrappings used that are not food grade
      • Operator to ensure all food containers/coverings/wrappings are made from food-grade materials
  5. Re-Inspection

    0 infractions

  6. Routine

    2 infractions

    • Food protected from potential contamination and/or adulteration
      • * Observed potentially hazardous food not covered to prevent contamination / adulteration
      • Operator to ensure all foods are covered in storage
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Contact licensed pest control operator for insect / rodent / pest treatment and control
  7. Routine

    0 infractions

  8. Re-Inspection

    0 infractions

  9. Routine

    2 infractions

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to ensure utensils are manually sanitized after each mechanical wash cycle