Grandview Discount Foods
600 Grandview St S, Oshawa ON L1H 8P4 · Food Safety Inspections
Inspection summary
Grandview Discount Foods has been inspected 12 times by Durham Region Health Department since November 18, 2024. The most recent inspection, on July 31, 2026, found no infractions.
2 of 12 inspections on record found no infractions at all. In the past 12 months there were 7 inspections with 14 infractions recorded. The higher-risk findings here relate to: Food temperature control, Pests and Chemicals and toxic substances.
The number of infractions per inspection has stayed roughly the same over time.
What these findings mean
Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.
Food temperature controlHigher risk
Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.
Recorded 4 times across 3 separate inspections, most recently on July 27, 2026. For example:
Potentially hazardous food is held at 4°C (40°F) or lower
PestsHigher risk
Signs of mice, rats, cockroaches or flies, or gaps and clutter that let them get in or hide. Pests carry bacteria and can contaminate food and surfaces, so evidence of activity is treated seriously and usually triggers a follow-up visit.
Recorded 3 times across 3 separate inspections, most recently on July 27, 2026. For example:
Adequate protection against the entrance of insects, vermin, and rodents
Chemicals and toxic substancesHigher risk
Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.
Recorded 3 times across 3 separate inspections, most recently on January 9, 2026. For example:
Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
Protecting food from contaminationHigher risk
This covers how food is stored, prepared and displayed: raw meat kept away from ready-to-eat food, food covered and stored off the floor, and nothing dripping or splashing into it. Cross-contamination from raw to cooked food is a direct route for salmonella and E. coli.
Recorded 2 times across 2 separate inspections, most recently on September 4, 2025. For example:
Food protected from potential contamination and/or adulteration
Cleaning and sanitizingHigher risk
Anything that touches food, such as cutting boards, dishes and utensils, must be washed, rinsed and sanitized. Inspectors check dishwasher temperatures, sanitizer strength and how wiping cloths are stored. Poor sanitizing lets bacteria survive from one use to the next.
Recorded once on January 22, 2026. For example:
Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
About this data
These results come from Durham Region Health Department, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.
12 inspections
- Re-Inspection
0 infractions
- Routine & Complaint
6 infractions
- Potentially hazardous food is held at 4°C (40°F) or lower
- * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
- CCP monitoring should be conducted by operator
- Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
- Frozen food is kept in a frozen state until sold or prepared for use
- * Fail to maintain frozen food in a frozen state
- Operator to ensure foods are maintained in a frozen state
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
- Operator to adjust or repair the malfunctioning freezer immediately. Do not store potentially hazardous foods in the unit until it is able to maintain foods in a frozen state.
- Adequate protection against the entrance of insects, vermin, and rodents
- * Evidence of pests observed
- Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
- Operator to ensure food premise shall be protected against the entry of pest
- Floors clean and in good repair
- * Fail to ensure floors of food premise are kept clean and/or in good repair
- Operator to ensure floors are kept clean and in good repair
- Ceilings clean and in good repair
- * Fail to ensure ceiling of food premise kept clean and in good repair
- Operator to ensure ceiling of the food premise is maintained in a sanitary condition and in good repair
- Potentially hazardous food is held at 4°C (40°F) or lower
- Re-Inspection
1 infraction
- Ceilings clean and in good repair
- * Fail to ensure ceiling of food premise kept clean and in good repair
- Operator to ensure ceiling of the food premise is maintained in a sanitary condition and in good repair
- Ceilings clean and in good repair
- Re-Inspection
0 infractions
- Re-Inspection
3 infractions
- Washing hands thoroughly before and after handling food
- * Food handlers fail to wash hands as often as necessary to prevent the contamination of food or food areas
- Food handlers must wash hands after they are contaminated and before handling food
- Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
- * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
- Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
- Operator to provide an appropriate test reagent to verify the concentration of the sanitizer
- Adequate protection against the entrance of insects, vermin, and rodents
- * Fail to ensure storage areas are clean and organized to facilitate monitoring of pest control
- * Fail to prevent the entrance of insect / rodent / pest
- * Evidence of significant pests observed
- Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
- Washing hands thoroughly before and after handling food
- Routine
3 infractions
- Separate hand washing basin provided for food handlers
- * Fail to ensure hand washing basin is easily accessible
- Operator to ensure a designated hand washing basin is provided and/or accessible in each food preparation area
- Operator to ensure designated hand washing basin is only used for hand washing
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Adequate protection against the entrance of insects, vermin, and rodents
- * Fail to ensure storage areas are clean and organized to facilitate monitoring of pest control
- * Evidence of pests observed
- Contact licensed pest control operator for insect / rodent / pest treatment and control
- Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
- Operator to ensure food premise shall be protected against the entry of pest
- Separate hand washing basin provided for food handlers
- Routine
1 infraction
- Minimum of 1 Certified Food Handler per hour of operation?
- * Fail to provide a minimum of 1 certified food handler per hour of operation
- Operator to ensure a minimum of 1 certified food handler is present during every hour of operation
- Minimum of 1 Certified Food Handler per hour of operation?
- Re-Inspection
1 infraction
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- Complaint
4 infractions
- Potentially hazardous food is held at 4°C (40°F) or lower
- * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
- CCP monitoring should be conducted by operator
- Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
- Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
- Washing hands thoroughly before and after handling food
- * Food handlers fail to wash hands as often as necessary to prevent the contamination of food or food areas
- Food handlers must wash hands after they are contaminated and before handling food
- Operator to wash hands before putting on disposable gloves
- Food protected from potential contamination and/or adulteration
- * Fail to ensure food products offered for sale are fit for human consumption
- Operator to ensure food products offered for sale are fit for human consumption
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
- Potentially hazardous food is held at 4°C (40°F) or lower
- Routine & Complaint
3 infractions
- Potentially hazardous food is held at 4°C (40°F) or lower
- * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
- Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
- Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
- Food protected from potential contamination and/or adulteration
- * Fail to ensure food products offered for sale are fit for human consumption
- Operator to ensure food products offered for sale are fit for human consumption
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
- Potentially hazardous food is held at 4°C (40°F) or lower
- Routine
4 infractions
- Minimum of 1 Certified Food Handler per hour of operation?
- * Fail to provide a minimum of 1 certified food handler per hour of operation
- Operator to ensure a minimum of 1 certified food handler is present during every hour of operation
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Sanitary maintenance of and provision of required supplies in staff / public washroom facilities
- * Fail to equip facility with toilet paper
- Operator to ensure the washroom facilities are properly supplied with soap/detergent, single-service towels or hot air dryer, toilet paper and hot and cold running water
- Minimum of 1 Certified Food Handler per hour of operation?
- Routine
3 infractions
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Lighting adequate for food preparation and cleaning
- * Fail to provide adequate lighting for food preparation and cleaning
- Provide adequate lighting for food preparation and cleaning
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
Nearby inspected facilities
- Bulldog Pub & Grill
600 Grandview St S, Oshawa ON L1H
5 inspections
- Angels Creamery and Devils Savoury
600 Grandview St S, Oshawa ON L1H 8P4
7 inspections
- King's Oshawa Buffet
4&5 600 Grandview St S, Oshawa ON L1H 8P4
6 inspections
- Circle K
600 Grandview St S, Oshawa ON L1H 8P4
2 inspections
- Grandview Nails
3 600 Grandview St S, Oshawa ON L1H 8P4
4 inspections
- Lovell Drugs
600 Grandview St S, Oshawa ON L1H 8P4
1 inspection
- Subway
21 600 Grandview St S, Oshawa ON L1H 8P4
3 inspections
- Artistic Roots Tattoo Co
600 Grandview St S, Oshawa ON L1H 8P4
2 inspections