Skip to content
Loading map…

LOCAL Wyoming ON

639 Broadway Street, Wyoming ON N0N 1T0 · Restaurant

Official record from Lambton →

Inspection summary

LOCAL Wyoming ON has been inspected 8 times by Lambton Public Health since November 29, 2024. The most recent inspection, on August 27, 2026, found no infractions.

1 of 8 inspections on record found no infractions at all. In the past 12 months there were 4 inspections with 6 infractions recorded. The higher-risk findings here relate to: Food temperature control, Protecting food from contamination and Chemicals and toxic substances.

Recent inspections have recorded fewer infractions than earlier ones, so the record is improving.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 10 times across 6 separate inspections, most recently on November 21, 2025. For example: Mechanical dishwashing: Wash / rinse water clean, correct water temperature and timing cycles, sanitizer at correct concentration (not a NSF/ANSI Standard 3 Dishwasher).

  • Protecting food from contaminationHigher risk

    This covers how food is stored, prepared and displayed: raw meat kept away from ready-to-eat food, food covered and stored off the floor, and nothing dripping or splashing into it. Cross-contamination from raw to cooked food is a direct route for salmonella and E. coli.

    Recorded 3 times across 3 separate inspections, most recently on April 17, 2026. For example: Food is protected from potential contamination (i.e. food covered, labelled, off floor, stored on racks, sneeze guard, physical hazards).

  • Chemicals and toxic substancesHigher risk

    Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.

    Recorded 2 times across 2 separate inspections, most recently on November 14, 2025. For example: Food contact surfaces properly designed, constructed, installed, maintained, and located (smooth, non-absorbent, cleanable, corrosion resistant, non-toxic and free from contamination).

  • Handwashing and staff hygieneHigher risk

    Hands are the main way germs like norovirus move from people to food. Inspectors look for stocked, accessible handwashing sinks, staff washing hands when required, hair restraints, and sick employees being kept away from food. Gaps here can spread illness quickly.

    Recorded once on November 29, 2024. For example: Hand washing basin is maintained and kept adequately supplied.

  • Building, plumbing and upkeepLower risk

    Floors, walls and ceilings must be smooth and clean, with working lighting, ventilation, plumbing, hot and cold water, and washrooms. These are rarely an immediate food-safety risk on their own, but persistent problems can lead to pest or sanitation issues.

    Recorded 3 times across 3 separate inspections, most recently on August 27, 2025. For example: Ceilings are clean and in good repair

About this data

These results come from Lambton Public Health, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

8 inspections

  1. Required

    0 infractions

  2. Required

    1 infraction

    • Food is protected from potential contamination (i.e. food covered, labelled, off floor, stored on racks, sneeze guard, physical hazards).
      • Fail to store food off the floor to prevent contamination.
  3. Follow-up

    1 infraction

    • Mechanical dishwashing: Wash / rinse water clean, correct water temperature and timing cycles, sanitizer at correct concentration (not a NSF/ANSI Standard 3 Dishwasher).
      • Fail to ensure chlorine sanitizer concentration is at least 100 parts per million at 24°C or greater for at least 45 seconds.
  4. Required

    4 infractions

    • Hazardous food is hot held at a minimum temperature of 60°C (140°F) after cooking or rapid re-heating.
      • Fail to hot-hold hazardous foods at 60°C (140°F) or higher after cooking or rapid re-heating.
    • Raw food products are separated from ready-to-eat food products during storage and handling.
      • Fail to handle / store raw hazardous foods separately or below ready-to-eat foods to prevent contamination.
    • Food contact surfaces properly designed, constructed, installed, maintained, and located (smooth, non-absorbent, cleanable, corrosion resistant, non-toxic and free from contamination).
      • Fail to store food dispensing scoop, or other approved food dispensing utensil, in a manner preventing contamination of the scoop, utensil, or food product being dispensed.
    • Mechanical dishwashing: Wash / rinse water clean, correct water temperature and timing cycles, sanitizer at correct concentration (not a NSF/ANSI Standard 3 Dishwasher).
      • Fail to provide sufficient detergent or chemicals for washing or sanitizing.
  5. Follow-up

    2 infractions

    • Sanitize test kit / thermometer is readily available for verifying dishwashing and sanitizing temperatures.
      • Fail to provide a sanitizing test kit to verify the concentration of the chemical agent being used.
    • Ceilings are clean and in good repair
      • Fail to ensure the ceiling of the food-handling room is kept clean and in good repair.
  6. Required

    4 infractions

    • Raw food products are separated from ready-to-eat food products during storage and handling.
      • Fail to handle / store raw hazardous foods separately or below ready-to-eat foods to prevent contamination.
    • Food contact surfaces properly designed, constructed, installed, maintained, and located (smooth, non-absorbent, cleanable, corrosion resistant, non-toxic and free from contamination).
      • Fail to store food dispensing scoop, or other approved food dispensing utensil, in a manner preventing contamination of the scoop, utensil, or food product being dispensed.
    • Sanitize test kit / thermometer is readily available for verifying dishwashing and sanitizing temperatures.
      • Fail to provide a sanitizing test kit to verify the concentration of the chemical agent being used.
    • Ceilings are clean and in good repair
      • Fail to ensure the ceiling of the food-handling room is kept clean and in good repair.
  7. Required

    2 infractions

    • Mechanical dishwashing: Wash / rinse water clean, correct water temperature and timing cycles, sanitizer at correct concentration (not a NSF/ANSI Standard 3 Dishwasher).
      • Fail to ensure chlorine sanitizer concentration is at least 100 parts per million at 24°C or greater for at least 45 seconds.
    • Sanitize test kit / thermometer is readily available for verifying dishwashing and sanitizing temperatures.
      • Fail to provide a sanitizing test kit to verify the concentration of the chemical agent being used.
  8. Required

    5 infractions

    • Hazardous food products are stored out of the temperature danger zone between 4°C (40°F) and 60°C (140°F) (except during periods of food preparation).
      • Fail to ensure that hazardous foods are kept out of the temperature danger zone (internal temperature of hazardous foods observed to be between 4°C (40°F) and 60°C (140°F)).
    • Hand washing basin is maintained and kept adequately supplied.
      • Fail to provide disposable paper towels from a dispenser in the food preparation area.
    • Mechanical dishwashing: Wash / rinse water clean, correct water temperature and timing cycles, sanitizer at correct concentration (not a NSF/ANSI Standard 3 Dishwasher).
      • Fail to ensure chlorine sanitizer concentration is at least 100 parts per million at 24°C or greater for at least 45 seconds.
    • Sanitize test kit / thermometer is readily available for verifying dishwashing and sanitizing temperatures.
      • Fail to provide a sanitizing test kit to verify the concentration of the chemical agent being used.
    • Floors are clean and in good repair.
      • Fail to ensure floor of food-handling room is kept clean and in good repair.

Nearby inspected facilities

Own this business? Add a badge to your website