Skip to content
Loading map…

Pakka Local Indian Kitchen & Bar

1050 Simcoe St N, Oshawa ON L1G 4W5 · Food Safety Inspections

Official record from Durham Region →

Inspection summary

Pakka Local Indian Kitchen & Bar has been inspected 10 times by Durham Region Health Department since March 31, 2025. The most recent inspection, on July 8, 2026, found no infractions.

5 of 10 inspections on record found no infractions at all. In the past 12 months there were 6 inspections with 19 infractions recorded. The higher-risk findings here relate to: Food temperature control, Handwashing and staff hygiene and Chemicals and toxic substances.

The number of infractions per inspection has stayed roughly the same over time.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 5 times across 4 separate inspections, most recently on July 7, 2026. For example: Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating

  • Handwashing and staff hygieneHigher risk

    Hands are the main way germs like norovirus move from people to food. Inspectors look for stocked, accessible handwashing sinks, staff washing hands when required, hair restraints, and sick employees being kept away from food. Gaps here can spread illness quickly.

    Recorded 3 times across 3 separate inspections, most recently on July 7, 2026. For example: Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels

  • Chemicals and toxic substancesHigher risk

    Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.

    Recorded 3 times across 3 separate inspections, most recently on July 7, 2026. For example: Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)

  • Cleaning and sanitizingHigher risk

    Anything that touches food, such as cutting boards, dishes and utensils, must be washed, rinsed and sanitized. Inspectors check dishwasher temperatures, sanitizer strength and how wiping cloths are stored. Poor sanitizing lets bacteria survive from one use to the next.

    Recorded 3 times across 3 separate inspections, most recently on July 7, 2026. For example: Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred

  • Protecting food from contaminationHigher risk

    This covers how food is stored, prepared and displayed: raw meat kept away from ready-to-eat food, food covered and stored off the floor, and nothing dripping or splashing into it. Cross-contamination from raw to cooked food is a direct route for salmonella and E. coli.

    Recorded 3 times across 3 separate inspections, most recently on April 23, 2026. For example: Food protected from potential contamination and/or adulteration

About this data

These results come from Durham Region Health Department, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

10 inspections

  1. Re-Inspection

    0 infractions

  2. Routine & Complaint

    8 infractions

    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Minimum of 1 Certified Food Handler per hour of operation?
      • * Fail to provide a minimum of 1 certified food handler per hour of operation
      • Operator to ensure a minimum of 1 certified food handler is present during every hour of operation
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure food contact surfaces are cleaned & sanitized after each use or as often as necessary
      • * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
      • Operator to ensure all food contact surfaces are properly cleaned & sanitized
      • Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
    • Walls clean and in good repair
      • * Fail to ensure walls of food premise kept clean and in good repair
      • Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
  3. Re-Inspection

    0 infractions

  4. Routine

    6 infractions

    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food protected from potential contamination and/or adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • * Observed raw foods stored above cooked / ready-to-eat foods
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure cooked and ready-to-eat foods are separated and above raw foods when handled or stored
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to provide sufficient detergent, chemicals, or required water temperatures for washing and sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure food contact surfaces are cleaned & sanitized after each use or as often as necessary
      • Operator to ensure wiping cloths are handled properly (sanitizing solution used)
  5. Re-Inspection

    0 infractions

  6. Routine

    5 infractions

    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
    • Separate hand washing basin provided for food handlers
      • * Fail to use basin only for hand washing of employees
      • Operator to ensure designated hand washing basin is only used for hand washing
    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food protected from potential contamination and/or adulteration
      • * Observed potentially hazardous food not covered to prevent contamination / adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure all foods are covered in storage
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  7. Re-Inspection

    0 infractions

  8. Routine

    4 infractions

    • Food protected from potential contamination and/or adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure food contact surfaces are cleaned and sanitized before and after food preparation
      • Operator to ensure all food contact surfaces are properly cleaned & sanitized
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
  9. Re-Inspection

    0 infractions

  10. Routine

    1 infraction

    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
      • Operator to ensure utensils are manually sanitized after each mechanical wash cycle
      • Operator to ensure mechanical dishwasher is maintained in good repair

Nearby inspected facilities

Own this business? Add a badge to your website