Rajdhani Sweets & Restaurant
1295 Ritson Rd N, Oshawa ON L1G 3V2 · Food Safety Inspections
11 inspections
- Re-Inspection
0 infractions
- Routine
2 infractions
- Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
- * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
- Chlorine sanitizer concentration must be at least 100 parts per million at 24°C or greater for at least 45 seconds
- Floors clean and in good repair
- * Fail to ensure floor of dishwashing area kept clean and in good repair
- Operator to ensure floors are kept clean and in good repair
- Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
- Routine
0 infractions
- Re-Inspection
0 infractions
- Routine
5 infractions
- Potentially hazardous food is held at 4°C (40°F) or lower
- * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
- CCP monitoring should be conducted by operator
- Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
- Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
- Thermometers used to verify food preparation and storage temperatures
- * Fail to use accurate thermometer to check storage temperature of potentially hazardous food
- Operator to provide accurate and easily readable indicating thermometers in temperature controlled rooms/equipment used for storage of potentially hazardous foods
- Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
- * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
- Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
- Separate hand washing basin provided for food handlers
- * Fail to ensure hand washing basin is easily accessible
- Operator to ensure a designated hand washing basin is provided and/or accessible in each food preparation area
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Potentially hazardous food is held at 4°C (40°F) or lower
- Re-Inspection
0 infractions
- Re-Inspection
3 infractions
- Separate hand washing basin provided for food handlers
- * Fail to ensure hand washing basin is easily accessible
- Operator to ensure a designated hand washing basin is provided and/or accessible in each food preparation area
- Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
- * Fail to provide hot and cold water for hand washing in food preparation area
- Operator to ensure hand washing basins are adequately supplied
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Separate hand washing basin provided for food handlers
- Routine
4 infractions
- Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
- * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
- Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating
- Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
- * Fail to provide hot and cold water for hand washing in food preparation area
- Operator to ensure hand washing basins are adequately supplied
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Adequate protection against the entrance of insects, vermin, and rodents
- * Fail to prevent the entrance of insect / rodent / pest
- Operator to ensure food premise shall be protected against the entry of pest
- Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
- Re-Inspection
0 infractions
- Routine
10 infractions
- Potentially hazardous food is held at 4°C (40°F) or lower
- * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
- Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
- Food is prepared in a safe manner
- * Fail to ensure food is prepared in a safe manner
- Do not thaw hazardous foods at room temperature
- Observed potentially hazardous foods not being thawed in an appropriate and safe manner
- Operator to ensure potentially hazardous foods are prepared in a safe manner
- Separate hand washing basin provided for food handlers
- * Fail to ensure hand washing basin is easily accessible
- * Fail to use basin only for hand washing of employees
- Operator to ensure a designated hand washing basin is provided and/or accessible in each food preparation area
- Operator to ensure designated hand washing basin is only used for hand washing
- Food protected from potential contamination and/or adulteration
- * Fail to protect food from contamination and/or adulteration
- Operator to ensure all food is properly stored, displayed, transported and served to prevent contamination
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to adjust or repair the malfunctioning cooler immediately. Do not store any potentially hazardous foods in the malfunctioning unit until it is able to maintain hazardous foods at 4° C or lower
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
- * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
- Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
- Sanitary maintenance of and provision of required supplies in staff / public washroom facilities
- * Fail to keep washroom in good repair, clean and sanitary condition
- Operator to ensure the washroom facilities are maintained clean and in good repair
- Floors clean and in good repair
- * Fail to ensure floors of food premise are kept clean and/or in good repair
- Operator to ensure floors are kept clean and in good repair
- Walls clean and in good repair
- * Fail to ensure walls of food premise kept clean and in good repair
- Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
- Potentially hazardous food is held at 4°C (40°F) or lower
- Routine
0 infractions