Skip to content
Loading map…

Stoneridge Mountain Resort - Whirlpool

30 Lincoln Park Canmore AB T1W 0H7 · Aquatic Facility

Official record from Alberta →

Inspection summary

Stoneridge Mountain Resort - Whirlpool has been inspected 18 times by Alberta Health Services (Environmental Public Health) since November 21, 2023. The most recent inspection, on June 9, 2026, recorded 2 infractions.

None of the 18 inspections on record were free of infractions. In the past 12 months there were 4 inspections with 7 infractions recorded. The higher-risk findings here relate to: Food temperature control, Pool and spa water quality and Chemicals and toxic substances.

Recent inspections have recorded fewer infractions than earlier ones, so the record is improving.

What these findings mean

Health authorities word their findings differently, so we group them by what they mean for the people using the facility. Higher-risk findings are the ones that could directly cause illness or injury, such as water that is not properly treated.

  • Food temperature controlHigher risk

    Inspectors check that anything that has to be kept at a set temperature, such as chilled or hot food, or equipment like sterilizers, stays in its safe range and that accurate thermometers are on hand. With food, temperature problems are one of the most common causes of food poisoning.

    Recorded 18 times across 18 separate inspections, most recently on June 9, 2026. For example: Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?

  • Pool and spa water qualityHigher risk

    For pools, spas and splash pads, inspectors test disinfectant levels, pH and water clarity, and check safety equipment. Water that is not properly treated can spread skin, ear and stomach infections.

    Recorded 16 times across 13 separate inspections, most recently on June 9, 2026. For example: Are the filtration, circulation and disinfection systems used to maintain water quality working properly (Non-Critical)?

  • Chemicals and toxic substancesHigher risk

    Pool chemicals such as chlorine and acid must be labelled, stored apart from each other and handled safely. Mixing them by mistake can release toxic gas, so storage and handling problems are treated seriously.

    Recorded 7 times across 7 separate inspections, most recently on September 4, 2024. For example: Is the chemical quality of the water in this pool satisfactory (Non-Critical)?

About this data

These results come from Alberta Health Services (Environmental Public Health), which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

18 inspections

  1. Monitoring Inspection

    2 infractions

    • 07. Are the filtration, circulation and disinfection systems used to maintain water quality working properly (Non-Critical)?
      • The minimum required flow rate for the whirlpool is 120gpm; the flow meters indicated the flow rate was only 100gpm. Flow rate to be maintained between 120-184gpm.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Some of the skimmers were missing weirs; corrected during inspection.
  2. Risk Management Inspection

    1 infraction

    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Flow rate for the whirlpool could not be determined as one out of the three flow meters were not functional. Repair flow meters so flow rate can be determined.
  3. Demand Inspection

    2 infractions

    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • Water sample submitted this week was not tested as the requisition form indicated it was taken on May 1/26 not June 1/26. New sample to be submitted this week.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Flow rate for the whirlpool could not be determined as one out of the three flow meters were not functional. Repair flow meters so flow rate can be determined.
  4. Demand Inspection

    2 infractions

    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • The water sample taken on December 8, 2025 was not tested as there was no id# sticker on the sampling bottle. Resample to be submitted this week.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Flow rate for the whirlpool could not be determined as one out of the three flow meters were not functional. Repair flow meters so flow rate can be determined.
  5. Demand Inspection

    2 infractions

    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • The water sample taken on October 6, 2025 was not tested as there was no id# sticker on the sampling bottle. Resample to be submitted this week.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Flow rate for the whirlpool could not be determined as one out of the three flow meters were not functional. Repair flow meters so flow rate can be determined.
  6. Demand Inspection

    2 infractions

    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • Water sample submitted on July 2, 2025 had a heterotrophic plate count of 280cfu/ml. Treat water to remove contamination. Resample.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Flow rate for the whirlpool could not be determined as one out of the three flow meters were not functional. Repair flow meters so flow rate can be determined.
  7. Demand Inspection

    2 infractions

    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • Water sample submitted this week was not tested as it was received by the lab over 24 hours after collection date written on the requisition form (written as April 1st). New sample to be submitted this week.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Flow rate for the whirlpool could not be determined as one out of the three flow meters were not functional. Repair flow meters so flow rate can be determined.
  8. Demand Inspection

    2 infractions

    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • March 17/25 water sample was not tested as there was no time of collection written on the requisition form. Resample to be submitted on Thursday, March 20th, 2025.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Flow rate for the whirlpool could not be determined as one out of the three flow meters were not functional. Repair flow meters so flow rate can be determined.
  9. Risk Management Inspection

    1 infraction

    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Flow rate for the whirlpool could not be determined as one out of the three flow meters were not functional. Repair flow meters so flow rate can be determined.
  10. Risk Management Inspection

    3 infractions

    • 06. Are the filtration, circulation and disinfection systems used to maintain water quality working properly (Critical)?
      • Chlorine injector appears to not be working properly. Did not appear chlorine was being injected into whirlpool line, could see chlorine leaking onto the floor from the injector. Pool operator started process of fixing it during inspection.
    • 07. Are the filtration, circulation and disinfection systems used to maintain water quality working properly (Non-Critical)?
      • pH was measured as 7.1, controller was reading 7.31. Calibration of pH probe needed.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Flow rate for the whirlpool could not be determined as two out of the three flow meters were not functional. Repair flow meters so flow rate can be determined.
  11. Monitoring Inspection

    2 infractions

    • 07. Are the filtration, circulation and disinfection systems used to maintain water quality working properly (Non-Critical)?
      • Controller was reading a pH of 7.38, when measured by inspector was 7.01 and when measured by pool operator was 7. Calibrate pH probe. Corrected during inspection.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • Whirlpool water temperature was measured as 41.5C; it not to exceed 40C.One of the weirs was missing from a skimmer; please replace.
  12. Demand Inspection

    3 infractions

    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • Water sample from Tuesday September 3rd, 2024, was not processed. Wrong date written on the forms. Operators were informed to submit a re-sample.
    • 05. Is the chemical quality of the water in this pool satisfactory (Non-Critical)?
      • Alkalinity was measured as 34ppm. Please maintain between 60-180ppm.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • One of the flow meters was not working. Repair/replace so flow rate can be determined.One of the weirs was missing. Please replace it.Pressure gauge for filter#3 was not working. To be repaired/replaced.
  13. Risk Management Inspection

    2 infractions

    • 05. Is the chemical quality of the water in this pool satisfactory (Non-Critical)?
      • Alkalinity was measured as 34ppm. Please maintain between 60-180ppm.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • One of the flow meters was not working. Repair/replace so flow rate can be determined.One of the weirs was missing. Please replace it.Pressure gauge for filter#3 was not working. To be repaired/replaced.
  14. Demand Inspection

    4 infractions

    • 02. Is the bacteriological quality of the water in this pool satisfactory (Critical)?
      • Water sample submitted on May 13/24 had Pseudomonas isolated. Immediately treat whirlpool to remove contamination and then submit a resample.
    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • Water sample submitted on May 13/24 had a heterotrophic plate count of over 57,000 cfu/ml. Treat water to remove contamination and then submit a resample.
    • 05. Is the chemical quality of the water in this pool satisfactory (Non-Critical)?
      • Alkalinity was measured as 34ppm. Please maintain between 60-180ppm.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • One of the flow meters was not working. Repair/replace so flow rate can be determined.One of the weirs was missing. Please replace it.Pressure gauge for filter#3 was not working. To be repaired/replaced.
  15. Risk Management Inspection

    2 infractions

    • 05. Is the chemical quality of the water in this pool satisfactory (Non-Critical)?
      • Alkalinity was measured as 34ppm. Please maintain between 60-180ppm.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • One of the flow meters was not working. Repair/replace so flow rate can be determined.One of the weirs was missing. Please replace it.Pressure gauge for filter#3 was not working. To be repaired/replaced.
  16. Demand Inspection

    4 infractions

    • 02. Is the bacteriological quality of the water in this pool satisfactory (Critical)?
      • Feb. 26/24 water sample had Pseudomonas isolated. Treat water to remove contamination.
    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • Feb. 26/24 water sample had a plate count of 980cfu/ml. Treat water to remove contamination.
    • 05. Is the chemical quality of the water in this pool satisfactory (Non-Critical)?
      • Alkalinity was measured as 34ppm. Please maintain between 60-180ppm.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • One of the flow meters was not working. Repair/replace so flow rate can be determined.One of the weirs was missing. Please replace it.Pressure gauge for filter#3 was not working. To be repaired/replaced.
  17. Demand Inspection

    3 infractions

    • 03. Is the bacteriological quality of the water in this pool satisfactory (Non-Critical)?
      • Jan. 2/24 water sample had a plate count of 320cfu/ml. Treat water to remove contamination.
    • 05. Is the chemical quality of the water in this pool satisfactory (Non-Critical)?
      • Alkalinity was measured as 34ppm. Please maintain between 60-180ppm.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • One of the flow meters was not working. Repair/replace so flow rate can be determined.One of the weirs was missing. Please replace it.Pressure gauge for filter#3 was not working. To be repaired/replaced.
  18. Monitoring Inspection

    2 infractions

    • 05. Is the chemical quality of the water in this pool satisfactory (Non-Critical)?
      • Alkalinity was measured as 34ppm. Please maintain between 60-180ppm.
    • 14. Is the pool maintained in a clean and sanitary condition, good repair and are temperatures being properly regulated?
      • One of the flow meters was not working. Repair/replace so flow rate can be determined.One of the weirs was missing. Please replace it.Pressure gauge for filter#3 was not working. To be repaired/replaced.

Nearby inspected facilities

Own this business? Add a badge to your website