Skip to content
Loading map…

SUNY Canton Rendezvous

34 Cornell Drive, Canton, NY 13617 · Restaurant (College Food Service)

Inspection summary

SUNY Canton Rendezvous has been inspected 10 times by New York State Department of Health (NYSDOH) since October 20, 2016. The most recent inspection, on December 8, 2025, recorded 1 infraction.

None of the 10 inspections on record were free of infractions. In the past 12 months there was 1 inspection with 1 infraction recorded. The higher-risk findings here relate to: Food temperature control, Protecting food from contamination and Cleaning and sanitizing.

Recent inspections have recorded fewer infractions than earlier ones, so the record is improving.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 4 times across 4 separate inspections, most recently on October 22, 2024. For example: Potentially hazardous foods are not kept at or above 140�F during hot holding.

  • Protecting food from contaminationHigher risk

    This covers how food is stored, prepared and displayed: raw meat kept away from ready-to-eat food, food covered and stored off the floor, and nothing dripping or splashing into it. Cross-contamination from raw to cooked food is a direct route for salmonella and E. coli.

    Recorded 3 times across 3 separate inspections, most recently on October 22, 2024. For example: Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)

  • Cleaning and sanitizingHigher risk

    Anything that touches food, such as cutting boards, dishes and utensils, must be washed, rinsed and sanitized. Inspectors check dishwasher temperatures, sanitizer strength and how wiping cloths are stored. Poor sanitizing lets bacteria survive from one use to the next.

    Recorded 2 times across 2 separate inspections, most recently on September 27, 2018. For example: Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred

  • Equipment and utensilsLower risk

    Equipment has to be built from cleanable materials, kept in good repair and stored properly. These findings are mostly about upkeep, like a cracked shelf, a worn gasket or utensils stored the wrong way. They are generally lower risk but show how well the kitchen is maintained.

    Recorded 14 times across 8 separate inspections, most recently on December 8, 2025. For example: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)

  • Building, plumbing and upkeepLower risk

    Floors, walls and ceilings must be smooth and clean, with working lighting, ventilation, plumbing, hot and cold water, and washrooms. These are rarely an immediate food-safety risk on their own, but persistent problems can lead to pest or sanitation issues.

    Recorded 6 times across 6 separate inspections, most recently on December 13, 2023. For example: Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans

About this data

These results come from New York State Department of Health (NYSDOH), which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

10 inspections

  1. Inspection

    1 infraction

    • 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
      • Not Critical Violation
  2. Inspection

    2 infractions

    • 8A: Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
      • Not Critical Violation
    • 6A: Potentially hazardous foods are not kept at or above 140�F during hot holding.
      • Critical Violation
  3. Inspection

    4 infractions

    • 15B: Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
      • Not Critical Violation
    • 5E: Enough refrigerated storage equipment is not present, properly designed, maintained or operated so that all potentially hazardous foods are cooled properly and stored below 45�F as required.
      • Critical Violation
    • 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
      • Not Critical Violation
    • 8A: Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
      • Not Critical Violation
  4. Inspection

    2 infractions

    • 2E: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
      • Critical Violation
    • 11D: Non food contact surfaces of equipment not clean
      • Not Critical Violation
  5. Inspection

    2 infractions

    • 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
      • Not Critical Violation
    • 15B: Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
      • Not Critical Violation
  6. Inspection

    1 infraction

    • 8A: Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
      • Not Critical Violation
  7. Inspection

    4 infractions

    • 15B: Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
      • Not Critical Violation
    • 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
      • Not Critical Violation
    • 11D: Non food contact surfaces of equipment not clean
      • Not Critical Violation
    • 12C: Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
      • Not Critical Violation
  8. Inspection

    4 infractions

    • 15B: Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
      • Not Critical Violation
    • 15A: Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
      • Not Critical Violation
    • 11D: Non food contact surfaces of equipment not clean
      • Not Critical Violation
    • 11C: Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
      • Not Critical Violation
  9. Inspection

    5 infractions

    • 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
      • Not Critical Violation
    • 15B: Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
      • Not Critical Violation
    • 11D: Non food contact surfaces of equipment not clean
      • Not Critical Violation
    • 8E: Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
      • Not Critical Violation
    • 15A: Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
      • Not Critical Violation
  10. Inspection

    4 infractions

    • 11D: Non food contact surfaces of equipment not clean
      • Not Critical Violation
    • 10B: Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
      • Not Critical Violation
    • 10A: Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
      • Not Critical Violation
    • 15B: Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
      • Not Critical Violation

Nearby inspected facilities

Own this business? Add a badge to your website