Tiny Hoppers Early Learning Centre - Kitchen
20 2620 Simcoe St N, Oshawa ON L1G 4R8 · Child Care Inspections
6 inspections
- Routine
1 infraction
- Adequate protection against the entrance of insects, vermin, and rodents
- * Fail to maintain premise free from every condition that may adversely affect the sanitary operation of the premise
- * Fail to maintain premise free from every condition that may adversely affect the food therein
- * Evidence of pests observed
- Contact licensed pest control operator for insect / rodent / pest treatment and control
- Operator to ensure storage areas are maintained clean and organized to facilitate the monitoring of pest control
- Adequate protection against the entrance of insects, vermin, and rodents
- Routine
3 infractions
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
- * Fail to provide mechanical dishwasher in good repair
- * Fail to provide sufficient detergent, chemicals, or required water temperatures for washing and sanitizing
- Hot water sanitizer must be at 82°C or greater for at least 10 seconds
- Operator to ensure mechanical dishwasher is maintained in good repair
- Operator to provide an easily readable thermometer to verify the dishwashing and sanitizing temperatures
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- Routine
1 infraction
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- Routine
2 infractions
- Potentially hazardous food is held at 4°C (40°F) or lower
- ° Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
- Operator to ensure potentially hazardous foods are held at 4°C (40°F) or lower
- Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
- * Fail to provide sufficient detergent, chemicals, or required water temperatures for washing and sanitizing
- Hot water sanitizer must be at 82°C or greater for at least 10 seconds
- Operator to ensure utensils are manually sanitized after each mechanical wash cycle
- Operator to ensure the appropriate chemicals and/or temperatures are used for proper washing and sanitizing
- Potentially hazardous food is held at 4°C (40°F) or lower
- Routine
1 infraction
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
- Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
- Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
- Routine
1 infraction
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
- * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
- * Fail to properly store food in food grade storage bags/containers
- * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
- Operator to ensure all food contact surfaces/equipment/utensils/multi-service articles are made of materials that are corrosion resistant/non-toxic/non-absorbent
- Operator to ensure all food containers/coverings/wrappings are made from food-grade materials
- Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)