Skip to content
Loading map…

Wimpy's Diner

2 219 King St E, Bowmanville ON L1C 1P7 · Food Safety Inspections

Official record from Durham Region →

Inspection summary

Wimpy's Diner has been inspected 8 times by Durham Region Health Department since October 30, 2024. The most recent inspection, on October 8, 2026, recorded 3 infractions.

1 of 8 inspections on record found no infractions at all. In the past 12 months there were 3 inspections with 7 infractions recorded. The higher-risk findings here relate to: Protecting food from contamination, Chemicals and toxic substances and Food temperature control.

Recent inspections have recorded more infractions than earlier ones, so it is worth reading the latest reports closely.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Protecting food from contaminationHigher risk

    This covers how food is stored, prepared and displayed: raw meat kept away from ready-to-eat food, food covered and stored off the floor, and nothing dripping or splashing into it. Cross-contamination from raw to cooked food is a direct route for salmonella and E. coli.

    Recorded 4 times across 4 separate inspections, most recently on October 8, 2026. For example: Food protected from potential contamination and/or adulteration

  • Chemicals and toxic substancesHigher risk

    Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.

    Recorded 3 times across 3 separate inspections, most recently on October 8, 2026. For example: Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 2 times across 2 separate inspections, most recently on January 7, 2026. For example: Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer

  • Handwashing and staff hygieneHigher risk

    Hands are the main way germs like norovirus move from people to food. Inspectors look for stocked, accessible handwashing sinks, staff washing hands when required, hair restraints, and sick employees being kept away from food. Gaps here can spread illness quickly.

    Recorded once on July 22, 2025. For example: Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels

  • PestsHigher risk

    Signs of mice, rats, cockroaches or flies, or gaps and clutter that let them get in or hide. Pests carry bacteria and can contaminate food and surfaces, so evidence of activity is treated seriously and usually triggers a follow-up visit.

    Recorded once on February 26, 2025. For example: Adequate protection against the entrance of insects, vermin, and rodents

About this data

These results come from Durham Region Health Department, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

8 inspections

  1. Routine

    3 infractions

    • Food protected from potential contamination and/or adulteration
      • * Observed raw foods stored above cooked / ready-to-eat foods
      • Operator to ensure cooked and ready-to-eat foods are separated and above raw foods when handled or stored
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are of sound and tight construction
      • Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
  2. Routine

    2 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are of sound and tight construction
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  3. Routine

    2 infractions

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Operator to ensure mechanical dishwasher is maintained in good repair
  4. Routine

    5 infractions

    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to maintain utensils, multi-service articles and/or food contact surfaces in a clean and sanitary manner and/or in good repair
      • Operator to ensure all food contact surfaces, utensils and/or multi-service articles are cleaned and sanitized after each use and are maintained in good repair
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
    • Walls clean and in good repair
      • * Fail to ensure walls of food premise kept clean and in good repair
      • Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
    • General housekeeping is satisfactory
      • * Fail to remove all materials not associated with the daily operation of the food premise
      • Operator to remove all materials not associated with the daily operation of food premise
  5. Routine

    2 infractions

    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
    • Food protected from potential contamination and/or adulteration
      • * Observed potentially hazardous food not covered to prevent contamination / adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • * Observed raw foods stored above cooked / ready-to-eat foods
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure cooked and ready-to-eat foods are separated and above raw foods when handled or stored
      • Operator to ensure all foods are covered in storage
  6. Re-Inspection

    0 infractions

  7. Routine

    3 infractions

    • Food protected from potential contamination and/or adulteration
      • * Fail to protect food from contamination and/or adulteration
      • Operator to ensure all food is properly stored, displayed, transported and served to prevent contamination
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Operator to ensure utensils are manually sanitized after each mechanical wash cycle
    • Adequate protection against the entrance of insects, vermin, and rodents
      • * Evidence of pests observed
      • Operator to ensure food premise shall be protected against the entry of pest
  8. Routine

    3 infractions

    • Food protected from potential contamination and/or adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair

Nearby inspected facilities

Own this business? Add a badge to your website