Skip to content
Loading map…

Canadore College - Main Cafeteria

100 College Dr North Bay ON P1B 8K9 · Restaurant

Official record from North Bay Parry Sound →

Inspection summary

Canadore College - Main Cafeteria has been inspected 8 times by North Bay Parry Sound District Health Unit since March 11, 2024. The most recent inspection, on September 18, 2026, recorded 3 infractions.

1 of 8 inspections on record found no infractions at all. In the past 12 months there were 3 inspections with 9 infractions recorded. The higher-risk findings here relate to: Food temperature control, Protecting food from contamination and Cleaning and sanitizing.

The number of infractions per inspection has stayed roughly the same over time.

What these findings mean

Health authorities word their violations differently, so we group them by what they mean for food safety. Higher-risk findings are the ones inspectors treat as critical, because they can directly make someone sick.

  • Food temperature controlHigher risk

    Bacteria multiply fastest between about 4 °C and 60 °C (40 °F to 140 °F). Inspectors check that cold food stays cold, hot food stays hot, cooked food is cooled quickly, and that staff have accurate thermometers. Temperature problems are one of the most common causes of food poisoning, so these are treated as critical findings.

    Recorded 4 times across 3 separate inspections, most recently on September 11, 2025. For example: Potentially hazardous food is held at 4°C (40°F) or lower

  • Protecting food from contaminationHigher risk

    This covers how food is stored, prepared and displayed: raw meat kept away from ready-to-eat food, food covered and stored off the floor, and nothing dripping or splashing into it. Cross-contamination from raw to cooked food is a direct route for salmonella and E. coli.

    Recorded 3 times across 3 separate inspections, most recently on February 9, 2026. For example: Food protected from potential contamination and/or adulteration

  • Cleaning and sanitizingHigher risk

    Anything that touches food, such as cutting boards, dishes and utensils, must be washed, rinsed and sanitized. Inspectors check dishwasher temperatures, sanitizer strength and how wiping cloths are stored. Poor sanitizing lets bacteria survive from one use to the next.

    Recorded 3 times across 3 separate inspections, most recently on September 11, 2025. For example: Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred

  • Chemicals and toxic substancesHigher risk

    Cleaning products, sanitizers and pesticides must be labelled and stored away from food and food-contact surfaces. Inspectors flag chemicals that could end up in food, as well as pest treatments applied without proper supervision.

    Recorded 2 times across 2 separate inspections, most recently on September 18, 2026. For example: Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)

  • Handwashing and staff hygieneHigher risk

    Hands are the main way germs like norovirus move from people to food. Inspectors look for stocked, accessible handwashing sinks, staff washing hands when required, hair restraints, and sick employees being kept away from food. Gaps here can spread illness quickly.

    Recorded once on February 9, 2026. For example: Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels

About this data

These results come from North Bay Parry Sound District Health Unit, which inspects food premises and other public facilities in this area. We republish the authority's public disclosure data and refresh it regularly; the official record is the final word.

8 inspections

  1. Compliance (Required)

    3 infractions

    • Proper storage of single-service containers/articles (utensils)
      • * Fail to store single-service containers and article (utensils) in a manner preventing contamination
      • Operator to ensure single-service containers/articles are protected and stored in a manner to prevent contamination
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to provide utensils and/or multi-service food containers/multi-service articles that can be readily cleaned and sanitized
      • Operator to ensure all food contact surfaces/equipment/utensils/multi-service articles are made of materials that can be readily cleaned and sanitized
    • Walls clean and in good repair
      • * Fail to ensure walls of food premise kept clean and in good repair
      • Operator to ensure walls of food premise are maintained in a sanitary condition and in good repair
  2. Compliance (Required)

    0 infractions

  3. Compliance (Required)

    6 infractions

    • Floors clean and in good repair
      • * Fail to ensure floors of food premise are kept clean and/or in good repair
      • Operator to ensure floors are kept clean and in good repair
    • Food protected from potential contamination and/or adulteration
      • * Observed potentially hazardous food not covered to prevent contamination / adulteration
      • * Observed scoops/utensils not being stored in a sanitary manner to prevent contamination and/or adulteration
      • Operator to ensure all food is properly stored, displayed, transported and served to prevent contamination
      • Operator to ensure scoops/utensils are stored and maintained in a sanitary manner to prevent contamination and/or adulteration
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Proper storage of single-service containers/articles (utensils)
      • * Fail to store single-service containers and article (utensils) in a manner preventing contamination
      • Operator to ensure single-service containers/articles are protected and stored in a manner to prevent contamination
    • Food contact surfaces properly designed, constructed, installed, maintained, located (smooth, non-absorbent, cleanable, corrosion resistant and non-toxic)
      • * Fail to use equipment/utensils/dishes/food containers/multi-service articles in good repair (i.e. free from cracks/crevices/chips/open seams)
      • Operator to ensure all food contact surfaces/equipment/utensils/multi-service articles are made of materials that can be readily cleaned and sanitized
    • Hand washing basin with supplies of hot and cold water, soap in a dispenser and single-use towels
      • * Fail to provide adequate supplies (single-use towels, soap in a dispenser) for the hand washing basin in the food preparation area
      • Operator to ensure hand washing basins are adequately supplied
  4. Compliance (Required)

    2 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Operator to conduct internal temperature checks of potentially hazardous foods
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure food contact surfaces are cleaned & sanitized after each use or as often as necessary
      • Operator to ensure all food contact surfaces are properly cleaned & sanitized
  5. Complaint & Compliance

    2 infractions

    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure food contact surfaces are cleaned & sanitized after each use or as often as necessary
      • Operator to ensure all food contact surfaces are properly cleaned & sanitized
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
  6. Compliance (Required)

    4 infractions

    • Food protected from potential contamination and/or adulteration
      • * Fail to protect food from contamination and/or adulteration
      • Operator to ensure all food is properly stored, displayed, transported and served to prevent contamination
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
    • Mechanical dishwashing: Wash / rinse water clean, water temperature, timing cycles, sanitizer
      • * Fail to ensure adequate sanitizer concentration are achieved for sanitizing
      • Quaternary ammonium compound must be at least 200 parts per million at 24°C or greater for at least 45 seconds
    • Food contact surfaces washed / rinsed / sanitized after each use and following any operations when contamination may have occurred
      • * Fail to ensure sanitizing solution contains the appropriate type of chemical solution and/or concentration/strength of sanitizer
      • Operator to ensure sanitizing solution contain the appropriate type of chemical solution and/or concentration/strength for sanitizing
  7. Compliance (Required)

    1 infraction

    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
  8. Compliance (Required)

    6 infractions

    • Potentially hazardous food is held at 4°C (40°F) or lower
      • * Fail to ensure potentially hazardous foods are held at 4°C (40°F) or less
      • Potentially hazardous foods observed at an internal temperature above 4° C (40°F)
    • Equipment, non-food contact surfaces and linen are maintained, designed, constructed, installed and accessible for cleaning
      • * Fail to maintain all equipment/non-food contact surfaces as readily cleanable and non-absorbent
      • * Fail to maintain all equipment/non-food contact surfaces are in clean and in good repair
      • * Fail to maintain all equipment/non-food contact surfaces are of sound and tight construction
      • Operator to ensure that all equipment/non-food contact surfaces are maintained clean and in good repair
      • Operator to ensure that all equipment/non-food contact surfaces are readily cleanable/non-absorbent and of sound and tight construction.
    • Floors clean and in good repair
      • * Fail to ensure floor of food-handling room kept clean and in good repair
      • Operator to ensure floors are kept clean and in good repair
    • Food protected from potential contamination and/or adulteration
      • * Fail to protect food from contamination and/or adulteration
      • Operator to ensure all food is properly stored, displayed, transported and served to prevent contamination
    • Food is prepared in a safe manner
      • * Fail to ensure food is prepared in a safe manner
      • Do not thaw hazardous foods at room temperature
      • Observed potentially hazardous foods not being thawed in an appropriate and safe manner
      • Operator to ensure potentially hazardous foods are prepared in a safe manner
    • Hot holding of potentially hazardous food: minimum of 60°C (140°F) after cooking / rapid re-heating
      • * Fail to hold potentially hazardous food at 60°C (140°F) or higher after cooking / rapid re-heating
      • CCP monitoring should be conducted by operator
      • Operator to ensure potentially hazardous foods are held at 60°C (140°F) or higher after cooking/rapid reheating

Nearby inspected facilities

Own this business? Add a badge to your website